2. Rugged Ridge
  3. XHD Stinger Grille Guard

Rugged Ridge XHD Stinger Grille Guard Installation guide

  • Hello! I have analyzed the provided document for the XHD Stinger Guard. This is an installation guide that details the necessary tools and hardware required, and provides a step-by-step process to mount the guard. I'm ready to answer any questions you have regarding the installation or features of the product.
  • What tools are required for installation?
    How many self-tapping screws are included?
    What should I be cautious about when drilling?
Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 1/2
Part # 11540.29
XHD Stinger Guard
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
CONTENTS:
• XHD Stinger Guard
TOOLS REQUIRED:
• Drill
• 9/64” Drill Bit
• Center Punch
• Phillips Head
Screwdriver
HARDWARE:
• Self-Tapping Screw (8)
Self-Tapping Screw x 8
XHD Stinger Guard
Careful attention is required to this instruction or operation, but does not generally relate
to pesonal injury. Damage to your product or other property may result if you do not follow
instructions.
NOTICE
Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 2/2
XHD Stinger Guard
2. Remove XHD Stinger Guard, re-mark hole locations
with a Center Punch, and drill pilot holes with a 9/64”
Drill Bit.
3. Place XHD Stinger Guard on XHD Stinger and
attach with the supplied Self-Tapping Screws using a
Phillips Head Screwdriver.
1. With XHD Stinger installed, allign XHD Stinger Guard
and mark hole locations.
NOTICE
Use caution when drilling pilot holes to
not drill through both sides of tube and
to ensure best possible t of product.
/