2. Reliance
  3. 13-090

Reliance 13-090 User manual

  • Hello! I've reviewed the installation instructions for the RELIANCE 13-090 USB/USB-C fast charger. This document provides detailed steps on mounting the device, securing it with the ring nut, connecting to 12V power, and indicates the presence of a power on/off button for constant power connections. The document also highlights the LED backlight feature. I am ready to address your questions about the installation and usage of this device.
  • What voltage is required for the charger?
    What tools are needed for installation?
    What does the LED backlight indicate?
installation instructions
13-090
USB/USB-C 12v Fast Charger
We recommend professional installation. If you choose to not have this product installed by a professional, we
highly recommend that you exercise caution, care, and patience when installing this product.
1
Locate the spot on your dash panel you wish
to mount the USB/USB-C. Be sure to check
the back side of this location for cart harness,
wires, or other obstructions before cutting.
Using the ring nut on the backside of the USB
as a template or a 1 1/8” Paddle Bit, drill out
the hole for your USB.
INCLUDED WITH KIT: TOOLS NEEDED:
• USB/USB-C
• 2 x Female Spade Connectors
• 1-1/8” Paddle Bit or Rotary Cutting Tool
Note: This USB/USB-C Charger is designed to operate on 12 volts ONLY.
Ring Nut
2
Notice on the backside of the USB that the
two terminals are marked (+) for Positive
and (-) for Negative connections.
4
3
Insert USB into mounting hole and secure
with the ring nut.
The USB is backlit w/LED that signies
when it is on. If you do not have the USB
hooked to a switched 12v source, there is a
built in Power Button to turn USB on/o for
constant power connections.
Before attaching the power wires to the
USB remove the ring nut and slide it over
the wires behind the mounting location.
Then attach your 12 volt wire connections
to the USB as shown.
Power Button
/