Eurolux FS32 Owner's manual

Brand: Eurolux

Model: FS32

Type: Owner's manual

MODEL

ILLUSTRATIONS

MODEL

Cape Town - 9 Racecourse Road, Milnerton, 7441

Johannesburg - 10 Milkyway Avenue, Linbro Business Park, Sandton, 2065

www.eurolux.co.za

Please read instructions before commencing installation and retain for future reference.

2 Light Security Light with Motion Sensor

Excluding: 2 X PAR38 GLS E27 maximum 150W

FS32

PRODUCT CODE

ENVIRONMENTAL PROTECTION

Waste electrical & Electronic equipment regulations requires that any of our products

showing this marking must not be disposed of with other household or commercial

waste. To prevent possible harm to the environment or human health from uncontrolled

waste disposal, please separate any such products from other waste types and recycle

it responsibly at your local facilities.

•Fitting: Plastic.

•Lamp type: Excluding: 2 X PAR38 GLS E27 maximum 150W.

•Voltage: 220V - 240V ~ 50Hz.

•Protection against electric shock: Class 2

•IP rating: IP33. Protected against solid foreign objects of 1.0mm Ø and greater. Protected

against spraying water.

•Maximum ambient temperature range: 20ºC - 40ºC

•Commercial/domesticuse.

•Suitableforoutdoorusewhenusedcorrectly.

•Detection angle: 130º

•Detection range: 12m

•Time delay: Adjustable from 5 seconds to 5 minutes

•Dimensions: (H) 125mm X (W) 200mm X (D) 175mm

Before commencing with installation ensure that the power to the electrical mains is turned off.

Electrical wiring (see gure 1).

Wiring colour key

BROWN=LIVE/BLUE=NEUTRAL/GREEN-YELLOW=EARTH/RED=SWITCH

• Opentheterminalboxcoverandremovethecablereliever.Unscrewtheinletscrewandremovethe

sealing ring.

• Threadthepowercablethroughtheinletscrewandthesealingring.Insertthewireendsintothe 

terminal block and then tighten them (pay attention to the earth marking on the terminal box).

• Relacethecablerelieverandtheboxcover.Screwintheinletscrewtogetherwiththesealingring.

Lamp installation (see gure 1):

• Thextureshouldbexedtothemountingsurfacewithtwoscrewsaspertheholesinthemounting

supporter.

• Thettingshouldbexedhorizontally.

Operation

• Theinfrareddetectorisequippedwiththreecontrolknobs:

Lux: Adjust the Lux switch for Day and Night sensitivity as indicated on sensor.

Time: Adjust the time switch for the duration you would want the light to remain on.

Sens: Adjust the Sens switch for the sensitivity of the motion sensor.

• Turnthepowerswitchtothe"ON"positionandwait30secondsforthesystemscircuittostabilize.

• Aimthecontrolmoduletothedesiredtargetarea.

Field of detection

• Theeldofdetectionoftheinfraredlampcanbeadjusted30ºhorizontallyand30ºvertically.

• Byadjustinghorizontally,thepermanent130ºrangeofdetectioneldcanbereducedtocutout

detection from the streets, or neighbouring grounds, or further expanded to include detection of

movement from neighbouring grounds and the surrounding streets.

• Thebestdetectionisobtainedbyapproachingtheeldofdetectionperpendiculartoitsaxis.

• Shouldthedetectioneldbeapproachedinthedirectionofitsaxis,theinfrareddetectormaytakea

few seconds to respond.

Walk Test

• Haveapersonstandapproximatelyinthecentreofthedetectionarea,andhavethemmovearound

within it.

• OncethePIRsensorreceivesavalidtriggersignal(suchasthemovementofaperson)withinits

 detectionarea,theoodlightwillbeturnedonforabout30secondsbeforedeactivating.

Possible problems

• Ventilatorssuchasthedischargefromavapourcapordryer(hotairmovement)maycausethelamp

to switch on when there is no need to.

• Passingcars(warmengines)mayalsocauseyourlamptoswitchon.

• Ifthelamphasbeenplacedunderarooforundertrees(shadedareas),thelampmayalsoburnduring

daylight hours.

• Shouldyourlampnotwork,pleasecheckthatthelampanditsfuseareinworkingcondition.Inthe

event that the lamp is in working condition, it may be possible that there has been a failure in the

electrical circuit.

• Ifthetemperaturedifferenceinthesurroundingareaandtheitemtobedetectedistoosmall(asin

summer time, where items retain heat for longer) your lamp may have a delayed reaction time.

• Yourlampwillnotworksatisfactorilyifitisplacedinsuchawaythattheeldofdetectionisnotwalked

through.

• Ifthereareuctuationelectromagneticinterferences(4KVelectrostaticdischarges,3V/m

 electromagneticHF-eldand1KVelectricaltesttransientburst),thenthelampmayturnon

unintentionally.

FS32 - attachments:

Iftheexternalexiblecableorcordofthisluminaireisdamaged,itshouldbeexclusivelyreplacedbythe

manufacturerorhisserviceagentorasimilarqualiedpersoninordertoavoidahazard.Toensurethat

you get maximum longevity and maximum use out of your luminaire, please observe the following safety

instructions.

Electrical products can cause death, injury, or damage to property. Installation of the luminaire must

 becarriedoutbyaqualiedelectrician,inaccordancewithSANS10142.Oncompletionof

 installation,ensurethattheCerticateofComplianceisupdated.

• Beforeconnectingthisluminaire,ensurethatvoltageindicatedontheratinglabelcorrespondswiththe

mains voltage in your home.

• Whenchangingthelamp,ensurethatthepoweristurnedoff.

• Thisluminaireischeckedinfullforconformitytothequalitystandardsandsafetyrequirements.

• Themanufacturer/supplierisnotresponsibleforanydamageofpropertiesandpersons,causedby

the incorrect use or installation of the luminaire.

• Shouldyoubeunsureofhowtoinstallthisluminairecorrectly,pleaseconsultaprofessionalelectrician

or your supplier for assistance.

• Ensureallitems/components,threadsandscrewsaretightlysecured.

IMPORTANT:

• Tamperingwiththisluminaire,I.E.Usingsiliconsealersorincorrectcabling,willinvalidateyour

warranty.

• Pleasecheckwhethertheconnectionofthepowercordissafeandreliablebeforeinstallation.

• Alwaysensurethatthemainssupplyvoltageiscorrect.

• Alwaysreplacethelampwithoneofanidenticalrating.

• Ensurethatyoudonotplacetheluminairenearanycombustiblematerialsand/orsurfaces.

• Chokinghazard:Maycontainsmallparts.Keepawayfromchildren.

• Donotinsertyourngersoranypartofyourbodyintotheelectricalcontactandsocketsofthis 

product whilst it is connected to the electricity supply.

• Itemmayvaryslightlyfromthepictureonthecarton.

• Coastalhumiditymayeffectthelongevityoftheluminaire.

• Outdoorluminairesmustbecleanedtopreventrustoccurring.

• Useacoppergreaseonallscrewsorthreads.

IMPORTANT SAFEGUARDS

INSTALLATIONSPECIFICATIONS

• Beforecleaningalwaysensurethepowersupplyisturnedoff.

• Donotimmersetheluminaireinwater.

• Noabrasiveproducts,solvents,detergentmaybeusedtocleanthisluminaire.

• Ensurethattheluminairedoesnotcomeincontactwithcorrosivechemicals,etc.

• Coastalareasensurethattheluminaireiscleanedfortnightly.

CLEANING

Eurolux FS32 Owner's manual

Eurolux FS32 Owner's manual

Eurolux FS32 Owner's manual

Related papers

Other documents