60min
MIDSLEEPER
Tools RequiredApproximate Assembly Time
ASSEMBLY
INSTRUCTIONS
Before you start....
Please carefully unpack and lay out all of the component parts to ensure nothing
is missing and to check each component for any obvious damage.
Should you identify any concerns at this stage please contact the retailer from
whom this product was purchased. Please quote your order number, details of
your issue, the product code, and the batch number from the cartons which will
help to resolve your issue as quickly as possible.
Product Code - PLU001/101/105/501
OPTION 01 OPTION 02
People Required to Assemble
1956mm
1207mm
1006mm
612mm
Version Number - 1.0
Contact Retailer
Please check all hardware matches the list below. Should
you notice any are missing please contact your retailer.
We strongly advise that you do not use Power Tools, such as
drills or electric screwdrivers during the assembly as this
may cause irreparable damage and will invalidate your
warranty.
A
42x
∅8x30mm
B
32x
∅10x30mm
C
8x
M6x16mm
D
30x
∅4x35mm
E
36x
∅4x40mm
F
1/4x82mm
4x
G
∅7x60mm
8x
H
1x
IJK
L
4x 4x 1x
2x
∅3,5x14mm
M
4x
N
8x
O
8x
P
2x
Q
8x
R
8x
Please ensure you carefully check all the pieces, should you have any
concerns please contact the retailer before assembly commences.
Please have your order number, details of the issue, the product code,
and the batch number from the cartons as this will help us to resolve
your issue much faster.
PARTS
1
1
2
2
3
3
4
4
5
5
6
7
8
9
01
03
03
02
02
04
04
05
05
06
01
07
09
08
10
11
11
12
12
13
16
14
15
15
15
15x
ASSEMBLY ADVICE
Please take the time to carefully read through these instructions
before you commence.
Keep these instructions for future reference.
We advise that the product is assembled in the room it is intended for.
We advise that you keep the hardware in a bowl during assembly to
avoid losing anything.
We strongly recommend that you keep children away from the work
area.
Small component parts could choke a child if swallowed.
We recommend you use a sheet or blanket to protect both floor and
product through the assembly stages.
This product is heavy, and we recommend a 2 person lift to avoid
personal injury or damage to the product.
Never push or pull the product as this could cause both personal injury
or irreparable damage to product or floor.
We have tried to make this piece of furniture easy to assemble if the
instructions are followed carefully.
In the unlikely event that you have problems with assembling the
product or have missing or damaged parts, please contact your
retailer and we will assist them in rectifying the problem as quickly as
possible.
Please remember we strongly urge you DO NOT use power tools such
as drill or electric screwdrivers as this could cause irreparable damage
to your product and will invalidate your warranty.
Distributed by : Julian Bowen Limited
Ben?nck House,
Park Lane Business Park,
Kirkby-in-Ashfield,
No?s, NG17 9LE
WARNING: This upper bed is not suitable for children under six years
CERTIFICATION LABEL
This bunk bed model has been tested
by an independent laboratory and is in
compliance with BS EN 747-1:2012 +
A1:2015 - Standard Consumer Safety
Specifica?on For Bunk Beds & High
Beds
Date of Manufacture: January 2016
Factory ID: Manufactured in Brazil
BARCELONA BUNK BED
Product Code: BAR008
Maximum height
of mattress
Distributed by : Julian Bowen Limited
Bentinck House,
Park Lane,
Kirkby-in-Ashfield Nos,
NG17 9LE
WARNING: This upper bed is not suitable for children under six years
CERTIFICATION LABEL
This bunk bed model has been tested
by an independent laboratory and is in
compliance with EN 747-1:2012 +
A1:2015 - Standard Consumer Safety
Specificaon For Bunk Beds & High Beds
Date of Manufacture: May 2019
Factory ID: Manufactured in Brazil
PLUTO MIDSLEEPER
Product Code:
PLU001C/ PLU101C
& BS8509:2008 + A1:2011 - Standart
Consumer Safety Specificaon For Junior
Beds
Maximum height
of mattress
Maximum height
of mattress
Maximum height
of mattress
OPTIONS
STARTS ON PAGE 20
1
Q
1º
2º M
C
4
5
Partially tighten Part C
CM
Q
Q
Q
QCM
8x
04
05 2x
2x
4x
1
2
3
A
A
A
A
A
A
E
E
E
E
E
2
3
A
12x
03
02
01
2x
8x
2x
5
67
FF
F1
2x
01
4
67
FF
F1
2x
01
1º
2º
3º
H
H
J
7
9
6
7
B
B
B
B
B
B
B
B
B
B
B
B
B
B
E
I
I
I
J
I
I
I
I
E
E
E
E
E
E
E
E
E
E
E
E
E
6
1
1
01
01
09
07
06
12x
12x
4x
4x
A
a
8
9
12
E
11
A
A
A
E
E
E
E
K
N
O
N
N
O
O
O
ON
N
AA
Q
12
11
5
4
N
O
Q
1º 3º
2º
AA
AA
AA
A
6x
2x 11
12
8x
8x
05
11
12
2x
04
16x
A
A
A
C
C
C
C
C
Partially tighten Part C
A
A
A
A
A
A
A
8x
4x
10
11
Fully tighten Part C
12
13
B
BB
10
1
E
EE
E
B
2x
01
10
2x
14
15
G
G
G
G
G
G
G
K
8
14
13
15
B
B
B
B
B
B
B
B
B
B
BB
BB
B
B
B
B
B
12x
6x
13
14
15
15
15
4x
08
6
16
17
B
B
B
B
G
G
K
_
13
14
10
E
E
E
E
2x
10
13
14
06
1x
2x
18
K
G
G
8
8
14
1
H
H
L
19
E
E
E
E
E
E
HH
L
HH
L
08
14
01
08
4x
1x
2x
4x
D
D
D
918 mm 918 mm
16
Attach the centre slat rst by pushing the side
rails together so that the slat is ush against the
side rail, before inserting the screws.
P
D
D
16
Next attach the remaining slats.
Place the slats onto the side rail supports and
distribute evenly by using the spacer provided.
20
16
16
16 14x
2x
28x
WARNING- This bed is not suitable for children under 4 years.
WARNING- Do not place this child’s bed near heat sources, windows and
other furniture.
WARNING- Do not use this child’s bed if any part is broken, torn or missing.
It is recommended that you always follow the manufacturer’s instructions to
assemble this product.
This product is intended for use by children over 4 years of age.
Children are likely to play, bounce, jump and climb on beds, therefore the
child’s bed shoult not be placed too close to other furniture or windows,
blind cords, curtain pulls or other strings or cords and should be placed
either tight to the wall or have a gap of 300mm between the wall and side of
bed.
This bed may not be dismantled for storage or transportation. Replacement
parts can be obtained from Julian Bowen Limited where available and at
additional cost.
Recommended Mattress Size: 90cm x 190 cm (UK Single) with a depth of no
more than 23 cm.
It is necessary to frequently ventilate the room in order to keep the humidity
low and to prevent mould in and around the bed.
Please periodically check all the xings of the itemand re-tighten when nacessary.
This item conforms to British Safety Standasds - BS8509:2008 + A1:2011
IMPORTANT INFORMATION FOR USE AS A SINGLE BED
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
