2. Lexmark
  3. 13H0300 - X 125 Color Inkjet
13H0300 - X 125 Color Inkjet

Lexmark 13H0300 - X 125 Color Inkjet, X125, X125 - Multifunction : 12 Ppm Quick Start

  • Hello! I am an AI chatbot trained to assist you with the Lexmark 13H0300 - X 125 Color Inkjet Quick Start. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What should I do if the installation software CD doesn't work?
    How can I ensure my Lexmark X125 is working properly?
Attach and extend the document exit tray.
Load plain inkjet paper.
Before you begin, read the safety information on the back of this sheet.
Connect the power cord.
1
2
3
4
5
6
www.lexmark.com
Extend the paper exit tray and the paper support.
Open the cartridge access doors.
7
Remove the sticker and
tape.
1
2
X125 All-In-One
Install the cartridges.
Enter the best values from the alignment
page.
9
1
0
11
8
Wait for the alignment page to print.
Connect the telephone cord.
1
3
• If you are using your All-In-One with
your computer, continue to the next
step.
• If you are using your All-In-One
without a computer, you are finished.
1
2
Close the cartridge access doors.
Extend the document support.
Connect the USB cable.
1
4
Insert the CD.Click Cancel.
1
5
1
6
Click Next. Follow the steps on your computer to install:
• Printer software, Quick Reference, and User’s Guide
• Photo editing software
• OCR scanning software
Setup questions?
Checking first things first
If your All-In-One has a problem, first make sure:
• The power cord is plugged into your All-In-One and into a properly grounded electrical
outlet.
• Your telephone cord is securely attached to the line jack on your All-In-One and to the wall
jack.
• Your telephone has a dial tone.
• The cartridge access doors are both completely closed.
• Ready appears on the display.
• The sticker and transparent tape covering the bottom of the cartridges are removed.
When I inserted the installation software CD, nothing happened.
1 Close all open programs.
2 Restart your computer.
3 Make sure you click Cancel on any screens similar to the one in step 15 on the setup
sheet.
4 Eject, and then reinsert the installation software CD.
5 From your desktop, double-click My Computer.
6 Double-click your CD-ROM drive icon. If necessary, double-click setup.exe.
7 Continue with step 17 on the setup sheet.
Refer to the Quick Reference for other setup and safety information.
P/N 13H0080 EC 3H0024
© Copyright 2002 Lexmark International, Inc. All rights reserved.
Safety information
• CAUTION: Do not make any cabling connections
during a lightning storm.
• Connect the power cord to properly grounded
electrical outlet that is near the product and easily
accessible.
/