Intermec 751G Operating instructions

Intermec
Brand
Intermec
Model
751G
Type
Operating instructions

This manual is also suitable for

CAC Reader Features
The CAC reader contains one status light and a SmartCard slot
reader. If the status light is on, then the SmartCard is being
powered.
SmartCard
slot reader
Status
light
Troubleshooting
Problem Possible Solution
You cannot read the
SmartCard.
Make sure the SmartCard is inserted properly
with the contacts facing the computer.
Clean the contacts on the CAC reader and
adapter.
Specifications
Operating temperature: 0°C to 50°C (32°F to 122°F)
Storage temperature: -20°C to 60°C (-4°F to 140°F)
6001 36th Avenue West
Everett, WA 98203
U.S.A.
www.intermec.com
© 2004 Intermec Technologies Corp.
All Rights Reserved
CAC Adapter and Reader Instructions
*074515-001*
P/N 074515-001
CAC Adapter and Reader Instructions
You can use the Common Access Card (CAC) reader with the
CN2G, CK31G, and 751G computers. For the CK31G and 751G,
you need to install a CAC adapter before you can attach the CAC
reader. The CAC reader enables your computer to read
ID-1 SmartCards.
For the CK31G and 751G, you need to install:
• CK31G CAC adapter (P/N 074245) or 751G CAC adapter
(P/N 074202)
• CAC reader (P/N 074102)
For the CN2G, you just need to install the CAC reader
(P/N 074102).
Do NOT use the CK31G, 751G, or CN2G with the
CAC reader installed when in a Division 2
hazardous environment.
Before installing or replacing the CAC adapter,
inspect the gaskets for wear or damage. Replace the
CAC adapter if you see any signs of wear or
damage.
Note: With the CAC adapter installed and the CAC
adapter cover closed, the CK31G and 751G
computers are approved for use in a Division 2
hazardous environment.
To install the CAC adapter and reader on a 751G or CK31G
1 Turn off the computer.
2 Unscrew the two captive screws on the SD card door and remove
it.
3 (751G only) Connect the CAC adapter cable on the CAC adapter
to the 751G.
751G
CAC adapte
r
CAC
adapter
cable
Captive
screw
(2 places)
4 Insert the CAC adapter and secure it with the two captive screws.
Make sure you tighten the screws securely (1.5 in-lb) to properly
seal the computer.
Captive
screw
(2 places)
CAC
adapter
CK31G
5 Open the CAC adapter cover.
6 Attach the CAC reader to the CAC adapter.
751G
CAC
adapter
CAC
reader
CAC adapter
cover
Note: If you have a CK31G, turn it over so that the
keypad faces up before attaching the CAC reader.
CK31G CAC adapter
cover
CAC
reader
CAC
adapter
7 Turn on the computer.
To attach the CAC reader to a CN2G
1 Turn off the computer.
2 Open the CAC port cover.
3 Attach the CAC reader to the CAC port.
CAC
reader
CN2G
4 Turn on the computer.
CAC port
cover
CN2G
  • Page 1 1
  • Page 2 2

Intermec 751G Operating instructions

Intermec
Brand
Intermec
Model
751G
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents