BARRON CBLS Series Color and Power Switchable LED Center Basket Installation guide

Brand
BARRON
Model
CBLS Series Color and Power Switchable LED Center Basket
Category
Motorcycle Accessories
Type
Installation guide
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
•DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations
if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
•The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS!
Technical Support ■ (623) 580-8943 ■ [email protected]
CBLS
Installation Instructions
20070155 REV 1 03/20 1 800-533-3948 www.barronltg.com
2X2 Fixture
2X4 Fixture
CBLS
Installation Instructions
20070155 REV 1 - 03/20 2 800-533-3948 www.barronltg.com
Recessed Grid Ceilings
1. Remove ceiling panel and neighboring panels for adequate access while installing the fixture (Fig. 1).
2. Place fixture, lens face down on a flat, clean surface and remove J-box cover.
3. Set adjustment switches on J-box as desired for wattage and color temperature (CCT) (Fig. 2 and 2a)
4. Take the fixture, rotate 45°, lift up and then through the ceiling grid (Fig. 3).
5. Remove appropriate knockout from J-box cover, connect conduit and make electrical connections; See Electrical
Connections section.
6. If dimming control device is used, run low voltage control wires into the driver J-box.
7. Locate (4 or 6 depending on the model) earthquake clips, pull tabs upright and twist out, then place fixture on
T-bar to hold in place (Fig. 4).
Note: If using T-bar clip once install to the housing place fixture on the T-bar to hold in place.
8. Install additional cable from fixture to ceiling structure to meet building code.
Fig. 1 Fig. 2
J-box cover
Fig. 2a
Fold the
Earthquake
clips 90° up
Earthquake clips
Twist out 90°,
clockwise
images
images
images
Fig. 3 Fig. 4 T-bar
Clips
CBLS
Installation Instructions
20070155 REV 1 - 03/20 3 800-533-3948 www.barronltg.com
Electrical Connections
Electrical connections should be made inside J-box.
a. Connect the line fixture lead to the black supply lead.
b. Connect the common fixture lead to the white supply lead.
c. Connect the ground lead from the service to the green grounding screw or to the ground lead coming from the housing.
Note: If dimming wires are not used, make sure they are capped.
This fixture auto adjusts for voltages between 120VAC - 277VAC.
Wiring Diagrams
Standard Fixture
Battery Backup Equipped
  • Page 1 1
  • Page 2 2
  • Page 3 3

BARRON CBLS Series Color and Power Switchable LED Center Basket Installation guide

Brand
BARRON
Model
CBLS Series Color and Power Switchable LED Center Basket
Category
Motorcycle Accessories
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents