Caution : You must read this before you proceed.
BISTRO TABLE
CAUTION : This table is NOT a TOY.
Keep your child / children at bay in the process of assembly.
Assembly Instructions
1 OF 4
NO. Picture QTY
D 1
E 3
K 1
F 7
G 4
11
11
11
I 1
J 1
Assembly Preparation
Before Beginning Assembly:
Hard ware
Parts list
Description
Table leg with pre-attached Leveller
Leg support
Table top
Spanner
Stud(M8*32mm)
Bolts(M8*35mm)
Washers(8mm)
Nuts(8mm)
Spring washers(8mm)
Screwdriver
H
2 OF 4
Assembly Step
Turn the Table rightside.
Adjust the Legs pre-installed Levellers until the table is level with the ground.
Upon completion of full assembly, bolt up and tighten up all screws.
Your table is now ready for use.
Lay the Table Top(D),Top being floor facing, onto a flat soft clean surface .
Fix the Studs(F) to the table Top(D) with the Screwdriver(I).
Then attach the Table Legs(E) to the the Table Top(D) using washers,Spring
washers,and Nuts(H) with the Spanner(J).
DO NOT OVER TIGHTEN,yet.
Attach the leg support(K)to Table Legs(E) using Bolts(G), Washers,Spring
washers, and Nuts（H）.
Use one Screwdriver (I) to hold the bolt, and with the other Spanner (J), turn in
the Nut(H).
DO NOT OVER TIGHTEN, yet.
Unpack and place all parts on a clean soft surface.
3 OF 4
4 OF 4
/
