MODEL NO: H-624IR
Instruction Manual
LOCATION OF CONTROLS:
1.ON/OFF Button
2.Light Battery Compartment
3.Remote Battery
4.Power Buttons
5.Dimmer
6.Preset Dimmer
7.Timer
8.Remote Battery Compartment
Battery Installations:
LIGHT
1.Open Battery cover
2.Install all (3) three AA Alkaline batteries, observing the indicated polarities (+)/(-) (Not included)
3.Close battery cover before use
Changing the Remote Control Battery
If the Remote Control does not work to turn the LED light ON, this may be an indication that the
battery needs to be replaced.
OPERATING INSTRUCTIONS:
ON/OFF/ Operation (LIGHT)
Press power symbol once for full brightness.
Press again to turn the light off.
Remote Control Operation: REMOVE PLASTIC TAB FROM REMOTE PRIOR TO USE
The remote control will operate lights within 15 feet. The remote uses Infra Red technology.
It is best to point the remote control at lights. Physical objects between the remote and lights may
interfere with the Infra Red signal. Up to 10 lights can be controlled by one remote control.
Power Buttons:
Red – Turns lights OFF
Green – Turns lights ON
Dimmer Buttons:
When lights are ON:
Hold - to decrease brightness
Hold + to increase brightness
Preset Dimmer Buttons:
When lights are ON press 50% or 100%
NOTE: Brightness level can only be controlled by the remote. Lights will default to last brightness
setting when you turn lights off by remote. If you want to adjust the brightness level of lights again,
please press (+)/(-) buttons on remote.
Timer:
When lights are ON press desired timer option (15, 30, 60 or 120 minutes). Lights will flash to
confirm setting. Reset timer by turning lights OFF.
WIRELESS LED REMOTE CONTROL
PUCK LIGHT
/
