Aigoss Car Stereo User manual

USER’S MANUAL

—— Bluetooth Multimedia Car Stereo FM Radio Receiver | Digital Media Bluetooth Receiver

OPERATION MANUAL

1. Connection:

Refer to the picture below.

**Please attention**: Different color cables connect different parts of your car.

2. Turn on / Turn off:

Power ON/OFF — Short press turn on; Short press turn off.

**Note**: When the first time to turn it on, there will be a FM noise. It is normal, because there is no FM signal. When next turn on, it will play the FM

station the last played.

3. Set the clock:

(1) Long press “CLK”, the “minute” twinkling, whirl the Volume control to choose.

(2) Short press "CLK" or Volume control, the "hour" twinkling, whirl the Volume control to choose.

(3) Long press "CLK" or wait 3 seconds to save.

**Note**: The time will still display when radio close in some cars, It depends on the pre-installation of each vehicle. There are cars in which the

radio car is connected so that it has its own power from the battery and other cars in which it is connected to the contact, so that when the key is

removed, the car radio stops receiving power. It is not a problem of the device, but the wiring of each car.

4. Search FM station:

(1) Automatically search :

① Short press AMS for the browser, it will search for FM87.5-108MHz in turn, and name the radio channel as F1P1~F1P6, F2P1~F2P6, F3P1~F3P6,

and totally 18 stations can be found.

② Play the radio stations (5 flashes) found in step① in order.

③ Back to the first radio station to play normally.

(2) Semi-automatically search:

Short press “>>” or “<<”, when meet the station you like, press the opposite button to stop searching.

5. Save the 1~6 stations:

When meet the station you like, long press the 1-6 button for 5 seconds. Then it will memory the station.

6. Bluetooth Mode:

Pairing:

(1) Short press the “BODE” button, the LCD will display the following sequence: TUNE—BT—AUX.

(2) Choose “BT”, you can search for the "CAR-BT" on your phone. Pair to device using the password "0000". Some phone automatically connect to the

search.

(3) Paired successfully, the LCD will display “BT ON”. MODE: short press to end call. BAND: short press to answer call.

7. USB/AUX Mode:

Insert USB disk or portable player by 3.5mm cable, in any playing mode, audio will come through the car speakers.

**Note**: The radio needs about 10s to read the file.

8. SD CARD Mode:

Insert the SD/MMC card in the slot by pushing it gently inward. Select SD with the mode selector. The music starts to play automatically.

**Note**: The radio needs about 10s to read the file.

9. 1/>1 BUTTON:

(1) Memory station 1 by pressing once to start playback.

(2) During "play" repress the button to pause playback. Press the button once more to resume play.

10. 2/INT BUTTON

(1) Memory station 2 by pressing once to start playback.

(2) When this button is pressed, “INT” indication is displayed and the first several seconds of each track is played. Press again to stop intro and listen to

track.

11. 3/RPT BUTTON

(1) Memory station 3 by pressing once to start playback.

(2) When this button is pressed, “RPT” indication is displayed and the selected track will be continually repeated until the track repeat mode is cancelled

by pressing the “RPT” button again.

12. 4/RDM BUTTON

(1) Memory station 4 by pressing once to start playback.