3M 17091CLR User manual

Category
Hooks
Type
User manual

3M 17091CLR Command Strips let you hang items on walls damage-free. They're perfect for smooth surfaces like painted walls, metal, glass, and finished wood. To apply, clean the surface with rubbing alcohol, separate the strips, remove the black liner and apply the strip, press firmly for 30 seconds, remove the blue liner and apply the hook, press firmly for 30 seconds. To remove, stretch the strip straight down along the wall at least 12 inches until it releases.

3M 17091CLR Command Strips let you hang items on walls damage-free. They're perfect for smooth surfaces like painted walls, metal, glass, and finished wood. To apply, clean the surface with rubbing alcohol, separate the strips, remove the black liner and apply the strip, press firmly for 30 seconds, remove the blue liner and apply the hook, press firmly for 30 seconds. To remove, stretch the strip straight down along the wall at least 12 inches until it releases.

See command.com for strip holding power for your product.
17091CLR
command.com
To Apply
To Remove
IMPORTANT: Failure to follow instructions carefully may cause damage!
SAVE INSTRUCTIONS for damage-free removal or visit command.com
PRESS FIRMLY along the
entire hook for 30 seconds.
Wait 1 hour before use.
Remove BLUE Liner and
apply hook to strip. Make
sure tab is accessible for
future removal.
Remove BLACKWall side”
Liner and apply strip to
desired location. PRESS
FIRMLY along the entire
strip for 30 seconds.
NEVER pull strip
towards you.
Hold hook gently to
prevent hook from
snapping fingers.
DO NOT press
hook against wall.
STRETCH STRAIGHT
DOWN ALONG WALL
AT LEAST 12 INCHES
(30 cm) until strip
releases from wall.
Best for SMOOTH
SURFACES. CLEAN surface
with rubbing alcohol, wipe
gently, let dry. Do not use
household cleaners.
SEPARATE strips.
BLUE
SIDE
31 2
30
SECONDS
3
12"
30 cm
30
SECONDS
4
1
2
STRAIGHT
DOWN
The following statements only apply to products distributed in the USA.
Limited Warranty:
This 3M product will be free from defects in material and manufacture.
If this product is defective, your exclusive remedy shall be, at 3M’s
option, replacement of the product or refund of the purchase price.
Limitation of Liability:
3M will not be liable for any loss or damage arising from this product,
whether direct, indirect, special,
incidental or consequential.
For questions, ideas and special offers go to command.com
Not intended for picture hanging.
Instead use Command
Picture
Hanging Strips, Sawtooth or
Wire-Backed Hangers.
Hooks can be reused with
Command
®
Medium Clear Strips.
NOTE:
Apply to surfaces above 50°F
(10°C). Adhesive could lose
adhesion above 105°F (40°C).
CAUTION:
DO NOT use on windows
or with wallpaper. May not
adhere well to vinyl surfaces
or textured surfaces. DO NOT
use for antiques, heirlooms,
or other valuable or
irreplaceable items. DO NOT
hang items over beds. Use
only one hook per item hung.
  • Page 1 1

3M 17091CLR User manual

Category
Hooks
Type
User manual

3M 17091CLR Command Strips let you hang items on walls damage-free. They're perfect for smooth surfaces like painted walls, metal, glass, and finished wood. To apply, clean the surface with rubbing alcohol, separate the strips, remove the black liner and apply the strip, press firmly for 30 seconds, remove the blue liner and apply the hook, press firmly for 30 seconds. To remove, stretch the strip straight down along the wall at least 12 inches until it releases.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI