2. Mercury
  3. 6220
6220

Mercury 6220 Operating instructions

  • Hello! I've reviewed the user manual for the Mercury Fibre Configuration D6220. This document provides detailed steps on how to set up your Netgear router with the Mercury network, including configuring the WAN settings, using PPPoE for internet access, and utilizing VLAN ID 10 to get connected. I'm ready to answer your questions about the setup and features described in this guide.
  • What is the default username to log in to the router?
    What are the default passwords for the router?
    What do I need to do if the default password does not work?
    What is the correct WAN Preference?
    What is the VLAN ID that needs to be used?
    What is the Internet Service Provider protocol?
Netgear D6220 Fibre Configuration
Using your own router? No worries, we’ve got you covered!
Log into the gateway:
1. Connect your device to the router (preferably hardwired)
2. Open a Web Browser
3. In the web browsers address bar type: www.routerlogin.net
4. Default Username: admin
5. Default Password: password or Admin (this may have been changed to your own)
This should then give access to the router’s user interface
(If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the
back for 10 seconds)
How to add correct settings for the Mercury network:
How to change the correct settings:
1. From the Advanced menu select: Setup
2. From the sub-menu select: WAN Setup
3. WAN Preference: Must Use Ethernet WAN
This will now reboot the router
1. From the Advanced tab select Setup
2. From the sub-menu select: Internet Setup
3. Select Country: NZ
4. Select Internet Service Provider: Other
5. Enable This Interface: Ticked
6. Use VLAN ID: Ticked – 10
7. Does your internet require a login: Yes
8. Internet Service Provider: PPPoE
9. Login: ((your mercury acct number)@mercurybroadband.co.nz
10. Password: password
11. Connection Mode: Always On
12. Click: Apply (top of page)This will again reboot the router
You should now be connected to Fibre!
/