Netgear D6220 Fibre Configuration

Using your own router? No worries, we’ve got you covered!

4. Default Username: admin

5. Default Password: password or Admin (this may have been changed to your own)

This should then give access to the router’s user interface

(If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the

back for 10 seconds)

2. From the sub-menu select: WAN Setup

3. WAN Preference: Must Use Ethernet WAN

This will now reboot the router

1. From the Advanced tab select Setup

2. From the sub-menu select: Internet Setup

6. Use VLAN ID: Ticked – 10

7. Does your internet require a login: Yes

8. Internet Service Provider: PPPoE

9. Login: ((your mercury acct number)@mercurybroadband.co.nz

10. Password: password