AOKE 2.4G Wireless Remote Control User manual

Hello! I have reviewed the provided user manual for the wireless remote control. It details how to pair the remote with your light string, control its features, and avoid interference with other remotes. The manual covers the pairing process, button functions for color selection and lighting effects, as well as FCC compliance information. I'm here to help you with any questions you might have regarding the device or the manual's instructions!
How to pair the wireless remote control?

How to turn on the remote control?

What happens if the pairing button is pressed again after a successful pairing?

Wireless remote control pairing instructions:

Pairing is to make the same remote control does not interfere with each other, if

there are two sets of the same remote control, No. 1 transmit and No. 1 receive

after pairing. It can only be operated by No. 1 remote control and received by No. 1

without causing any action to No. 2. Wireless remote control pairing.

operation:

1. Connect the light string to the power supply and enter the waiting pairing stage.

2. Hold down the ON/OFF button of the remote control for 3 seconds and release it

to emit the pairing signal.

When the receiver is powered on, it will first enter the pairing state. If the previously

paired remote control emits a signal within 15 seconds, the pairing light will be

immediately extinguished. And have a corresponding action. For the remote control

that is not paired with it, press the ON/OFF button of the remote control for 3

seconds to successfully pair with it.

Note:

Sequence of matching code: the light string should first enter the matching state,

and then make the remote control emit pairing signal. Then the match can be

successful. After code matching is successful, please do not press the pairing button

again. Even if the power is off, you do not need to pair again. If you press the pairing

button of the remote control again, you will lose control of the previous receiver and

need to pair again to make it work.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause

undesired operation.

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.