SmartStraps 1500 LB Ratchet Strap User manual

1500 LB Ratchet Strap
Brand
SmartStraps
Model
1500 LB Ratchet Strap
Type
User manual

This manual is also suitable for

SmartStraps 1500 LB Ratchet Strap: Secure cargo effectively with a safe working load limit of 500 pounds. Simple installation process includes attaching hooks to anchor points, passing webbing over cargo, and pumping the ratchet handle to tension. Ensure proper tension by observing the 1-1/4 – 1-1/2 turns of the split axle while tightening, and re-tension if necessary. Once secured, close the ratchet handle to lock the mechanism. For release, pull the spring-loaded pawl and open the ratchet fully.

SmartStraps 1500 LB Ratchet Strap: Secure cargo effectively with a safe working load limit of 500 pounds. Simple installation process includes attaching hooks to anchor points, passing webbing over cargo, and pumping the ratchet handle to tension. Ensure proper tension by observing the 1-1/4 – 1-1/2 turns of the split axle while tightening, and re-tension if necessary. Once secured, close the ratchet handle to lock the mechanism. For release, pull the spring-loaded pawl and open the ratchet fully.

1,500 LB RATCHET STRAP
INSTALLATION INSTRUCTIONS
IF YOU EXPERIENCE ANY PROBLEMS WITH YOUR SMARTSTRAPS PRODUCT DO NOT
RETURN THE UNIT TO THE RETAILER FROM WHICH IT WAS PURCHASED. INSTEAD,
PLEASE CALL 1-844-295-9218 FOR ASSISTANCE WITH ANY PROBLEMS. WARRANTY
INFORMATION IS AVAILABLE UPON REQUEST AND CAN BE FOUND ONLINE AT
SMARTSTRAPS.COM.
WINSTON PRODUCTS COMPANY
SMARTSTRAPS.COM
WINSTON PRODUCTS, LLC.
30339 DIAMOND PARKWAY
CLEVELAND, OH 44139
©05/2022
WARNING: Read and observe all warnings, instructions, and capacity limitations before using this product. Failure to comply with this
warning and the associated instructions and capacity limitations may result in serious personal injury and/or signicant property damage.
INSTRUCTIONS:
1. Attach hook WITHOUT Ratchet mechanism to a suitable anchor point.
2. Pass webbing over cargo.
3. Attach hook WITH Ratchet mechanism to a suitable anchor point.
4. Pass free end of webbing through split axle of Ratchet and pull to remove slack.
5. Pump Ratchet handle to tension webbing while being careful not to over-tighten.
6. Rated capacity is based upon 1-1/4 – 1-1/2 turns of the split axle while tensioning the webbing. Tie down must be re-tensioned if the
split axle turned less than 1-1/4 turns.
7. Once cargo is properly secured, close Ratchet handle fully to lock the mechanism.
8. To release, pull spring loaded pawl in handle and open Ratchet a full 180 degrees.
SAFE WORKING
LOAD LIMIT
500 lb (227 kg)
445
CORREA CON MATRACA PARA 1,500 LB
INSTRUCCIONES DE INSTALACION
ADVERTENCIA: Lea y siga todas las advertencias, instrucciones y limitaciones de capacidad antes de usar este producto. El
incumplimiento de esta advertencia y las instrucciones asociadas y las limitaciones de capacidad puede resultar en lesiones personales
graves y o daños materiales signicativos.
INSTRUCCIONES:
1. Conecte el gancho SIN mecanismo de trinquete para un punto de anclaje adecuado.
2. Pase las correas más de la carga.
3. Conecte el gancho con el mecanismo de trinquete para un unto de anclaje adecuado.
4. Pase el extremo libre de la trama a través del eje división de trinquete y tire de él para eliminar la holgura.
5. Trinquete de mango de la bomba a la tensión, mientras que las correas con cuidado de no apriete en exceso.
6. La capacidad nominal se basa en 1-1/4 - 1-1/2 vueltas del eje rasguen durante el tensado de la correa. Amarre bien se debe volver
a tensados si el eje de división se volvió menos de 1-1/4 vueltas.
7. Una vez que la carga esté bien seguro, cerca de la palanca de trinquete para bloquear totalmente el mecanismo.
8. Para soltar, tirar muelle del trinquete cargado en el mango de trinquete y abra un completo de 180 grados.
UNA EMPRESA DE WINSTON PRODUCTS
SMARTSTRAPS.COM
WINSTON PRODUCTS, LLC.
30339 DIAMOND PARKWAY
CLEVELAND, OH 44139
©05/2022
LÍMITE DE
CARGA MÁXIMA
DE SEGURIDAD
500 lb (227 kg)
SI LISTED PRESENTA CUALQUIER PROBLEMA CON SU PRODUCTO SMARTSTRAPS NO
DEVUELVA LA UNIDAD A LA TIENDA DON DE COMPRÓ. AL CONTRARIO, POR FAVOR
LLAME AL 1-844-295-9218 PARA OBTENER AYUDA CON CUALQUIER PROBLEMA.
LA INFORMACIÓN DE LA GARANTÍA ESTÁ DISPONIBLE A PETICIÓN Y SE PUEDE
ENCONTRAR EN LÍNEA EN SMARTSTRAPS.COM.
445
  • Page 1 1
  • Page 2 2

SmartStraps 1500 LB Ratchet Strap User manual

1500 LB Ratchet Strap
Brand
SmartStraps
Model
1500 LB Ratchet Strap
Type
User manual
This manual is also suitable for

SmartStraps 1500 LB Ratchet Strap: Secure cargo effectively with a safe working load limit of 500 pounds. Simple installation process includes attaching hooks to anchor points, passing webbing over cargo, and pumping the ratchet handle to tension. Ensure proper tension by observing the 1-1/4 – 1-1/2 turns of the split axle while tightening, and re-tension if necessary. Once secured, close the ratchet handle to lock the mechanism. For release, pull the spring-loaded pawl and open the ratchet fully.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents