8820-03378 Rev.A00
F1DN-RK10-4U: BELKIN EXTENDER RACKMOUNT KIT FOR 10 UNITS 4U
Objectives
• Scan the QR code or visit Belkin Cybersecurity YouTube Playlist for Secure KVM Unboxing and Troubleshooting videos.
• This guide includes instructions for Belkin F1DN-RK10-4U.
• This Manual and additional product documentation is available for online download on Belkin website. For further assistance please refer to:
https://www.belkin.com/products/product-resources/cybersecurity/resources/.
Quick Installation Guide
Belkin Extender Rack Kit for 10 units with Mounting Plates & Screws
F1DN-RK10-4U Model is shown
Pre-installation Guidelines
• Determine where you will mount the Rack Mount and the orientation of
the Rack Mount.
• Ensure the Rack Mount will be installed on a flat, clean, and dry surface.
This Rack Mount is not intended for exposed outdoor installation.
• Ensure that distance between the Extenders, PSU, Secure KVM/KM and
each computer does not exceed cabling lengths or Extender supported
distances.
• Ensure that once the Rack Mount is installed the Extender ports are
accessible.
• F1DN-RK10-4U is compatible with the following Belkin Extenders:
–F1DN-KVM-EXTC6 Extender Transmitter Copper CAT6 - Universal
Video (4K 60Hz 4X2X0)
–F1DN-KVM-EXRC6 Extender Receiver Copper CAT6 - Universal Video
(4K 60Hz 4X2X0)
–F1DN-KVM-EXTC6X Extender Transmitter Copper CAT6 - Universal
Video (4K 60Hz 4X4X4)
–F1DN-KVM-EXRC6X Extender Receiver Copper CAT6 - Universal
Video (4K 60Hz 4X4X4)
–F1DN-KVM-EXTFI Extender Transmitter Fiber SFP - Universal Video
(4K 60Hz 4X2X0)
–F1DN-KVM-EXRFI Extender Receiver Fiber SFP - Universal Video (4K
60Hz 4X2X0)
Package Contents
• F1DN-RK10-4U 10 Units Rack
• 10 Support Mounts
• 20 Screws to Rack Mount, Each Support Mount Requires 2 Screws
• 40 Screws for Mount, Each Extender Enclosure Requires 4 Screws
HDBaseTRCU
PWR LINKVIDEO PoE
DC 48V
KVM Extender
Support Mount
+ 4 x Screws
+ 2 x Screws
Rack Mount
Verify that all peripherals and
computers are turned OFF prior to
connecting them to the product.
Set Extender into Support Mount.
Attach Extender to Support Mount
using 4 included screws.
Each Extender enclosure requires 4 screws to
attach to Support Mount.
Attach Support Mount to Rack Mount
using 2 included screws.
Each Support Mount requires 2 screws to
attach to Rack Mount.
Repeat steps 3 – 5 for all
Extenders installed into
Rack Mount.
Dimensions
• Rack Mount: 19 (W) x 6.25 (H) x 7 (D) inches /
482.6 (W) x 158.75 (H) x 177.8 (D) mm
• Mounting Brackets: 6.13 (W) x 4.38 (H) x 1.5 (D)
inches / 155.70 (W) x 111.25 (H) x 38.1 (D) mm
• Weight: 3.90 lbs / 1.77 kg
Assembled Product
