Belkin F1DN-KVM User guide

Type
User guide
Secure KVM Switch
Belkin Secure KVM Under Desk Mount Quick Start Guide
F1DN-KVM-MOUNT:
The Belkin Secure KVM Under Desk Mount is designed for quick deployment and attaches to the KVM via tension.
There are no screws required to fasten the KVM to the bracket.
Included Contents:
1
SKVM Under Desk Mount
4 ¾-inch screws
Pre-Installation Guidelines
Determine where you will be placing the mount and orientation of the mount. (see
below)
Desktop
Mounting under the desk
Mounting vertically on the side
KVM mounting options
Ensure the mount will be installed on a flat, clean, and dry surface. This mount is not intended for
exposed outdoor installation.
Ensure that maximum distance between the KVM mount and each computer does not exceed your
cabling lengths.
Ensure that the keyboard, mouse, and display cables will reach the mounted KVM.
Ensure that the KVM port buttons are easily visible and accessible by the intended user.
Ensure that the included screws are adequate size and type for the designated installation area.
(Replacement for F1D006 and F1D008)
8820-00349 Rev A00
Installation
1.
Once you have determined the location, screw the mount to the desk using the screws provided.
Mounting the KVM
1. Connect all necessary cables to the back of the KVM.
2. With the KVM forward facing, align the rails to the side-tracks on the KVM.
3. Slide the KVM back until it stops.
4. Tighten thumb screws on each side.
8820-00349 Rev A00
Secure KVM Switch
  • Page 1 1
  • Page 2 2

Belkin F1DN-KVM User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI