CKBC24

nVent Hoffman CKBC24 User manual

Hello! I have reviewed the Installation Instructions for the Keyboard Box 64347001 by nVent. This document details the procedures for mounting the keyboard box, securing the keyboard with velcro strips, routing cables, using the sliding mouse trays, and using a mouse bracket. I'm ready to assist with any questions you might have about this installation guide.
How to install the keyboard box?

How to secure the keyboard?

Where should the keyboard and mouse cable go?

How to use mouse trays?

Where to place the mouse?

© 2018 Hoffman Enclosures Inc. PH 763 422 2211 • nVent.com/HOFFMAN 87568815

Rev. B P/N 64347001

M6 Screw

Small Gasket

Large Gasket

Mounting Surface

Mounting Hole

Mouse Bracket

Cable

Routing Hole

Keyboard Support

Velcro Strips

Grommet

M6 Cage Nut

Keyboard Box

Mouse Tray

Keyboard Box

INSTALLATION INSTRUCTIONS:

1. Use square mounting holes on back surface of keyboard box as

a template for drilling holes in mounting surface.

2. Drill holes and mount unit as shown.

3. Keyboard may be secured to keyboard support with velcro strips

provided.

4. Cables from keyboard and mouse may be fed through cable

routing hole in rear of keyboard box.

5. Mouse trays slide out from either end of keyboard box.

6. Mouse may be slid into mouse bracket at rear of keyboard box.

/

Other documents