The Great Outdoors 8881-A39 User manual

Brand: The Great Outdoors

Model: 8881-A39

Type: User manual

INSTALLATION INSTRUCTIONS

Item#8881-A39/A61 (Rev. 05/10/2012)

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

Fig. 2

Fig. 3

PREPARATION (Fig. 1)

1. Shut off power at the circuit breaker and remove the old

fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts

on a clear area. Take care not to lose any small parts

necessary for installation.

3. Remove finial (H) from the fixture. Secure the scrolled

end of arm (F) to the top of the fixture with finial (E). Next,

secure the straight end of arm (F) to backplate (P) using

knurled knobs (G) washers (I) and hex nuts (J).

4. Replace finial (H), previously removed.

5. Mount the reinforcement plate (K) to the junction box and

secure with screws (M) through the holes in the middle of

the plate. For additional stability on large fixtures, use the

4 screws and anchors (L & N) provided. The side of the

reinforcement plate marked “GND” must face out. (Fig. 1)

CONNECTING THE WIRES (Fig. 2)

6. Connect the electrical wire as shown in figure 2, making

sure that all wire connectors are secured. If your outlet

has a ground wire (green or bare copper), connect the

fixture ground wire to it. Otherwise, connect the fixture

ground wire directly to the reinforcement plate using the

green screw provided. After wires are connected, tuck

them carefully inside the outlet box.

COMPLETING THE INSTALLATION

7. Align the fixture to the mounting screws on the

reinforcement plate (K) and secure fixture with knurled

knobs (O). (Fig.1)

8. To prevent moisture from entering the outlet box and

causing a short, use clear caulking (i.e. Indoor/Outdoor

Silicone Sealant) to outline the outside of fixture back

plate where it meets the wall leaving a space at bottom to

allow moisture a means to escape. (Fig. 3)

9. Remove the bottom finial (A), lock washer (B) tube (R),

and metal leaf (Q). Carefully slide out the bottom

assembly (C). Remove any plastic bag material from the

socket cluster. Proceed to install the B10.5 2*60W bulbs

(not included) in accordance with the fixture’s

specifications. (DO NOT EXCEED THE MAXIMUM

WATTAGE RATING). (NE PAS DEPASSER LA

PUISSANCE NOMINALE MAXIMALE!).

10. Replace the bottom assembly (C) and secure with the

metal leaf (Q), tube (R), lock washer (B) and Finial (A).

Your installation is now complete. Return power to the

junction box and test the fixture.

Note: Illustration (Fig. 1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

LA-2000E

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

Backplate

Caulking

“U.S. Patents; D461,593;D465,604

This product is protected by Untied States Federal and/or

State Law, including Patent and/or Copyright laws.”

The Great Outdoors 8881-A39 User manual

The Great Outdoors 8881-A39 User manual

The Great Outdoors 8881-A39 User manual

Related papers

Other documents