Connect wires from wall sconce to 120V
power feed in junction box with wire nuts
Companion Wall Sconces
INSTALLATION INSTRUCTIONS
1.
Secure ground lead from wall sconce to
ground wire or a grounded surface
2.
3.
Secure universal mounting bracket to the
junction box with 2 screws (not provided)
5.
Install lamp and turn on power
LAMP MUST NOT EXCEED THE MAXIMUM
WATTAGE AS INDICATED ON THE FIXTURE
LABEL
6.
Mount wall sconce to universal mounting
bracket with the provided screws
4.
www.jescolighting.com
1. Turn o power at fuse box before installing/maintaining/servicing/modifying the system
2. Do not install in damp or wet locations
3. Do not attempt to energize anything other than a qualied lighting xture
4. Check with a qualied electrician before wiring
5. Conrm installation shall be in accordance with NEC and all local codes
NOTE: If you need to shorten the pendant length, please refer to the quick pendant
eld cut instructions below
Save these installation instructions and refer to them when
additions or changes to congurations are made
CAUTION
Read all of these instructions before installation:
/
