4. Installation
I: Inspection
Remove the AVR from the shipping package and inspect the unit. Be sure that nothing inside the
package is damaged.
II: Placement
Please install the AVR in a protected environment.
Do NOT block the top or side air vents on the unit. Please
reserve 20cm space to avoid interference.
Do NOT operate the AVR where the temperature and humidity
is outside the specific limits. (Please check the specs for the
limitations.)
III: Connect to Utility and Charging
Plug in the AC input cord to the wall outlet.
IV: Connect Your Equipment
Plug equipment into the AVR rear-panel outlets. Then switch the unit on by press the front panel
power switch to “RESET” position.
5. Operation
I: Setting Startup Delay Time Switch
Delay : Setting delay time as 3 minutes. It’s designed to avoid damage devices with AC
motor from consecutive starts. It’s perfect to use with devices such as refrigerators, freezers,
air conditioners or dehumidifiers.
Undelay : Setting delay time as 10 seconds. It’s designed for use with voltage sensitive
equipment such as: personal computers, monitors, inkjet printers, scanners or faxes. It’s also
designed for use with home appliances such as televisions, stereos, CD/DVD players, VCRs,
modems, and telephone equipment.
II: Setting Input Voltage Range
The total power consumption of all equipment plugged into the AVR must not exceed
its capacity (Refer to spec). It may cause the breaker to fault (blow).