MULTIPLEX Electrical Connector Change out Linix Motor Installation guide

Part No. 020002825

Revision 0

Electrical Connector Change out on Linix Motor Instructions

Parts Included in Kit No.: 020002826

Qty. Description Part Number

1 ……Motor Linix Crusher…………. 020002708

2 ……Piggyback Amp Insulated …… 020002823

2…….Amp Female Receptacle……… 020002824

1…….Install Instructions……………. 020002825

Connector Instructions

1. Disconnect Power to beverage dispenser

and ice maker. Failure to do so may

cause electrical shock or injury.

2. Remove current Linix motor from

dispenser.

3. While removing Linix from

dispenser, check to see what type of

electrical connectors are on Red and

Black wires. See Figure (1A).

4. New motor will come with the

connectors shown in Figure (2B).

5. If motor you removed has connectors

shown in Figure (1A). Cut the female

spade terminal connectors off the Red

and Black wires on replacement

motor. Replace with provided

piggyback spade terminal connectors

provided with kit.

Figure 1

Figure 2

This manual is also suitable for