02 Get to know your navigation system
Before starting
02
13
General
You can use the navigation system without
having selected a destination. The map with
the position of the car is shown on the screen
and the car is shown with a blue triangle.
The system is updated continuously and could
therefore contain functions not described in
this manual.
Map mode
On startup, the system starts by displaying a
screen where the text content has to be con-
firmed by pressing ENTER.
Then the display switches to Map mode, and
the current map image covers the entire
screen.
•
Press BACK to reach the Main menu, see
page 30.
•
Press ENTER to reach the Quick menu,
see page 28.
1.
Press the navigation button to activate
Scroll mode, in order to view parts of the
map that are outside of the screen for
example.
2.
In this mode ENTER activates the Scroll
menu, see page 31.
Settings
The system is supplied with default settings,
but starts with the settings last made.
If a setting has been changed and the factory
setting is required again then only the current
function is affected.
There is no function that resets all settings
simultaneously.
On/Off
On
1. The remote control key must be inserted
into the ignition switch (see the owner's
manual for the car).
2.
Press ENTER or BACK.
3. The display is activated automatically.
The system may need a few seconds in order
to detect the position and movement of the car.
Off
The system is shut down automatically when
the remote control key is removed from the
ignition switch.
The system can also be switched off manually,
so that it does not start automatically the next
time the remote control key is inserted into the
ignition switch:
1.
Press BACK to reach the Main menu.
2.
Scroll to
Shut down with the navigation
button.
3.
Press ENTER.
4. The display is toned down or switched off.
NOTE
The system can be accessed even if the
engine is switched off. The system is
switched off in the event of low battery volt-
age.
Demo (simulated guidance)
To get an idea of how guidance works you can
set a destination. When the car is stationary
you can simulate guidance to the specified
destination, see Start demo see page 49.
P3; 4; 3 2008-03-20T13:01:05+01:00; Page 13
siggejohansson