RockJock CE-9081 Installation guide

Hello! I've reviewed the installation instructions for the Currie heavy duty shackles, specifically the YJ CE-9038, CE-9039, CE-9040, and CE-9081 models. I understand the proper assembly, torque requirements, and maintenance needs for these shackles, aimed for Jeep CJ and Scrambler vehicles. Feel free to ask me any questions you may have about the installation or usage.
How should the shackles be assembled?

What is the torque for the center brace?

What is the torque for the shackle bolts?

When should I check the torque of the shackle bolts?

What type of grease should be used?

76-86 Jeep CJ and Scrambler - Shackle Install Instructions

Assemble shackles onto the Jeep with the grease ttings toward the outside, and the lock nuts on the inside.

Tighten the center brace rst to 60 ft. lbs. (standard (non-boomerang) YJ rear shackles do not have a center brace!),

then torque the shackle bolts to 50 ft. lbs. Check torque on the shackle bolts after 100 miles, and re-check peri-

odically after that. Grease with multi-purpose chassis grease or moly lube. If you have any questions during the

installation of this product please contact our technical department at (714) 528-6957.

76-86 Jeep CJ and Scrambler - Shackle Install Instructions

Assemble shackles onto the Jeep with the grease ttings toward the outside, and the lock nuts on the inside.

Tighten the center brace rst to 60 ft. lbs. (standard (non-boomerang) YJ rear shackles do not have a center brace!),

then torque the shackle bolts to 50 ft. lbs. Check torque on the shackle bolts after 100 miles, and re-check peri-

odically after that. Grease with multi-purpose chassis grease or moly lube. If you have any questions during the

installation of this product please contact our technical department at (714) 528-6957.