2. Riverside Furniture
  3. 79809

Riverside Furniture 79809, 79812 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the Riverside Furniture End Table, model 79809. This document provides a comprehensive guide on how to assemble your new end table, including detailed diagrams and steps for each part. I'm here to assist you with any questions you may have about the assembly process or parts.
  • What should I do before I start the assembly?
    What is the first step in the assembly?
    When should I fully tighten the bolts?
Made in Viet Nam
Riata Tables
Assembly Instructions
Component And Hardware List
Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment. Separate, count and check all parts against the Components and Hardware List below.
Left Leg
email: info@riverside-furniture.com
Page 1 of 1
Right Leg
Table Top
(A) (B) 2 PCS. (C) 2 PCS.
(E)
4mm
Allen Wrench
1 PC.
12 PCS.
Bolt:
Ø5/16" - 18 x 50mm
(G)
Flat Washer
Ø 5/16" x 19mm
(F)
Spring Washer
Ø 5/16"
(H)
12 PCS.
12 PCS.
Item #79809
END TABLE
1 PC.
THANK YOU FOR YOUR PURCHASE.
DETAIL A
H
E
G
F
ASSEMBLY PROCEDURE:
1. Remove the Drawer from the
Table Top (A) and lay the Table
Top upside down on a soft and
smooth surface.
3. Assemble the Shelf (D) to the four Legs (B & C) by
using Bolts (E) Spring Washer (F) & Washer (G)
as shown in DETAIL B, using the Allen key (H).
2. Assemble the Left & Right
Legs (B & C) into the proper
corners of the Table Top (A) by
using Bolts (E) Spring Washer (F)
& Washer (G) as shown in
DETAIL A.
Do not fully tighten Bolts
until after Detail B.
H
E
G
F
4. Turn the assembled Table
upright and reinstall the drawer.
DETAIL B
Shelf
(D) 1 PC.
B
C
B
C
/