PRO SIGNAL PSG3415 Operating instructions

Brand
PRO SIGNAL
Model
PSG3415
Type
Operating instructions
PSG3415
IN WALL CSR WIRELESS MUSIC RECEIVER
1
IMPORTANT SAFETY INFORMATION
Please read these inructions carefully before use and retain for future reference.
• Check that the voltages indicated on any PSU rating plate that may be used is correct
for the mains supply and for powering this device.
• Ensure the power supply is correct and polarity is observed if using screw terminals.
• Do not expose to excessive heat or locate where damp or moiure may enter the
device.
OVERVIEW
• This device can receive audio from an external wireless device or from a wired input
via the jack socket, and send to a wired stereo loudspeaker system.
• Use a soft cloth to wipe off any dust. If the device is very dirty, use a damp cloth and
wipe dry.
• Do not use any chemicals, abrasives or solvents that could damage the casing.
WHAT’s IN THE BOX
• Wallplate receiver.
• Instruction Manual.
INSTALLATION
• Press the PAIRING button for 3 seconds to turn on, press button again for 3 seconds
to turn off.
• On initial pairing, hold down the button for 5 seconds to enter the pairing mode. The
LED with flash rapidly while searching for a device.
• On your source device enable wireless pairing mode and select the wallplate device.
• The LED will flash slower when a device is detected. If your device demands a pass
code, enter “0000”.
• The pairing time out limit is 90 seconds.
• If pairing times out, you need press the button again for 1 second to re-initialise
pairing mode.
• Once pairing is successful the LED will remain lit continuously.
2
SPECIFICATIONS
MAINTENANCE
Audio Inputs : Wireless receiver or stereo audio line level .
Audio source select: Auto switch over, the priority is BT when playing.
Audio output: Stereo audio phone jack or 3-pin screw terminal.
Power input (5VDC): Power jack or 2-pin screw terminal.
Stereo audio output: For connection to any speaker syem.
Wireless version: v5.0.
Wireless range: 10 meters.
Power source: 5VDC 1A
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in Taiwan
PO Box 13362 Dublin 2
PR2 9PP
Man Rev 1.1
CPC Farnell declares that the radio equipment for wireless transmitter/receivers is in
compliance with Radio Equipment Directive 2014/53/EU
  • Page 1 1
  • Page 2 2

PRO SIGNAL PSG3415 Operating instructions

Brand
PRO SIGNAL
Model
PSG3415
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents