2. KILLARK
  3. Spartan Pole Series Retrofit

KILLARK Spartan Pole Series Retrofit Installation guide

  • Hello! I'm an AI assistant, and I've reviewed the Installation, Operation & Maintenance Data Sheet for the HUBBELL SPARTAN Pole. This document provides instructions for retrofitting existing light poles, and it includes details on using the hinge mechanism, wiring, and the tools needed for installation. I'm ready to answer your questions about the SPARTAN Pole.
  • What is the wind rating for the SPARTAN Pole?
    In what type of environment is the SPARTAN Pole suitable for?
    What type of tools are required for installation?
HUBBELL ELECTRICAL PRODUCTS
A Division of HUBBELL INCORPORATED (Delaware)
2112 Fenton Logistics Park Blvd.
Fenton, Missouri 63026 USA
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
SERIES SPARTAN POLE
P/N KIL00921301 FORM NO. K1301 04/21 ERO 8-018-21 Page 1 of 4
GENERAL GUIDELINES
• Please read the following instruction carefully and use the product accordingly.
• This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed.
TOOLS REQUIRED:
Suitable for use in Class I
Div. 2 when installed in
accordance to NEC 501.
E27731
Type 3R
Rated 250mph
HUBBELL ELECTRICAL PRODUCTS
A Division of HUBBELL INCORPORATED (Delaware)
2112 Fenton Logistics Park Blvd.
Fenton, Missouri 63026 USA
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
SERIES SPARTAN POLE
P/N KIL00921301 FORM NO. K1301 04/21 ERO 8-018-21 Page 2 of 4
ATTACH THE
RETROFITTER TO
THE LIGHT POLE.
THE MIDDLE OF THE
HINGE SHOULD BE
APPROX 2” ABOVE
THE HANDRAIL
LOWER THE POLE
90 DEGREES UNTIL
THE HINGE IS FULLY
OPEN
LINE THE CUTTER UP
WITH THE MIDDLE
OF THE HINGE AND
CUT THE POLE
UNDO THE WIRING
AND REMOVE THE
OLD FIXTURE
1 2
LOOSEN THE TOP
CLAMP 2 TURNS
LOOSEN THE
LOCK BOLT AND
OPERATE THE CAM
MECHANISM
3 4
5 6
HUBBELL ELECTRICAL PRODUCTS
A Division of HUBBELL INCORPORATED (Delaware)
2112 Fenton Logistics Park Blvd.
Fenton, Missouri 63026 USA
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
SERIES SPARTAN POLE
P/N KIL00921301 FORM NO. K1301 04/21 ERO 8-018-21 Page 3 of 4
REMOVE WIRING
FROM POLE AND
REMOVE POLE FROM
CLAMP
THREAD THE CABLE
UP THE TOP POLE
AND INSERT THE
POLE INTO THE
HINGE
REMOVE THE
RETROFITTER FROM
THE BOTTOM POLE
ATTACH AND WIRE
THE NEW FIXTURE
THREAD THE WIRE
THROUGH THE
HINGE
INSTALL THE HINGE
ON THE BOTTOM
POLE.
THERE IS NO NEED
TO DEBUR THE
HINGE INTERNAL
POLE SOCKETS
PROTECT THE
CABLE
7 8
9 10
11 12
HUBBELL ELECTRICAL PRODUCTS
A Division of HUBBELL INCORPORATED (Delaware)
2112 Fenton Logistics Park Blvd.
Fenton, Missouri 63026 USA
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
SERIES SPARTAN POLE
P/N KIL00921301 FORM NO. K1301 04/21 ERO 8-018-21 Page 4 of 4
RAISE THE POLE TIGHTEN THE HINGE
TOP SET SCREWS.
TIGHTEN THE LOCK
BOLT
13 14
/