2. FOS
  3. Neon Flex RGB

FOS Neon Flex RGB Installation guide

  • Hello! I've reviewed the Quick Guide for the LED Neon Flex Neonflex-24V, which details its specifications, operating instructions, and installation process. The guide mentions light source options (RGB or single color), cutting specifics, power requirements, and waterproofing. I'm ready to answer your questions about this product.
  • What is the cutting length of the LED Neon Flex?
    What is the power input for the LED Neon Flex?
    What type of light source does the RGB LED Neon Flex use?
    What is the IP rating of the LED Neon Flex?
    What is the maximum length per power input for LED Neonflex-24V?
    What should be used for waterproof?
Color: RGB or single color (Red,Green,Blue,White,Warm White,Amber,Pink)
Light source: SMD5050 (RGB) / 2835 (single color)
Cutting length: 0.5m
Power/meter: 14.4W
Power input: DC 24V
Max. length/power input: 10m
Length: 50m per roll
IP rating: IP67
Quick Guide
SPECIFICATIONS
INSTALLATIONS
OPERATING INSTRUCTION
The LED Neonflex-24V works on Ribbon Driver series or constant voltage LED driver.
Com
Red
Green
Blue
LED Neonflex
Power In
DMX CONTROLLER
to avoid voltage drop, 10m max.
Cut at cutting mark At the end, use End Cap
and silicon glue for water-
proof.
Use mounting clips and
scews to install the Neon-
flex for desired pattern.
Insert power pin into the
other end and connect 4
wires inside.
Connect with power cable
and use glue for water-
proof.
/