AX-12 Installation Guide Rev.B.doc
AX- 1 2 v 1 . 0
R S 4 8 5 B u s P r o t e c t i o n
M o d u l e
C o n s t r u c t i o n a n d a p p l i c a t i o n
AX-12 is a protection module dedicated to RS485 bus exposed to high electric
interferences. AX-12 has been designed for RACS system and should not be used in
other RS485 systems.
I n s t a l l a t i o n
The AX-12 should be installed according to fig.1 below. All electrical connections
should be carried out with power supply off. It's recommended to connect single
AX-12 module every 50-100m of RS485 cable.
Fig.1 Typical connection diagram of AX-12
Nominal 12VDC, min./max. range 10-15VDC
Average current consumption
Working temperature range
0 – 95 % (non-condensing)
RS485 bus protection module
The first commercial product version
This symbol placed on a product or packaging indicates that the
product should not be disposed of with other wastes as this may
have a negative impact on the environment and health. The user is
obliged to deliver equipment to the designated collection points of
electric and electronic waste. For detailed information on recycling,
contact your local authorities, waste disposal company or point of
purchase. Separate collection and recycling of this type of waste
contributes to the protection of the natural resources and is safe to
health and the environment. Weight of the equipment is specified in
the document.
Contact:
Roger sp. z o.o. sp.k.
82-400 Sztum
Gościszewo 59
Tel.: +48 55 272 0132
Fax: +48 55 272 0133
Tech. support: +48 55 267 0126
Web: www.roger.pl