IS-0206 Rev. O Page 1 of 1
Installation/Instruction Sheet
19” Drawer Façade,
1U
IS-0206 Rev O
OnQ Technologies, Inc.
P.O. Box 60907
Harrisburg, PA 17106-0907
800-321-2343
www.onqtech.com
Figure 1
1. Introduction
The OnQ 19” Drawer Façade, 1U, P/N 364583-01 is mounted onto a 19” OnQ Custom Rack Drawer and
provides the spacing required when installing “taller” modules within the drawer. The 19” Drawer Façade is
1U, or 1 unit high and provides the spacing requirements needed when mounting additional units within a
standard 19” Rack System.
2. Description
The OnQ 19” Drawer Façade, 1U is a formed piece of sheet metal with three mounting holes. When mounted
to a 19” OnQ Custom Rack Drawer, this Façade will use 1 unit of space within a standard 19” Rack System
(see Figure 1).
3. Installation
A. Mounting onto a 19” OnQ Custom Rack Drawer
1. Line up the three mounting holes located in the Façade to the three mounting holes in the top
of the Drawer.
2. Install the three #6-32UNC-2B x .38 lg. self-tapping screws into the holes and tighten (see
Figure 2).
Figure 2
/
