Legrand 19" Drawer Façade, 1U - 364583-01 Installation guide

IS-0206 Rev. O Page 1 of 1

Installation/Instruction Sheet

19” Drawer Façade,

IS-0206 Rev O

OnQ Technologies, Inc.

P.O. Box 60907

Harrisburg, PA 17106-0907

800-321-2343

www.onqtech.com

Figure 1

1. Introduction

The OnQ 19” Drawer Façade, 1U, P/N 364583-01 is mounted onto a 19” OnQ Custom Rack Drawer and

provides the spacing required when installing “taller” modules within the drawer. The 19” Drawer Façade is

1U, or 1 unit high and provides the spacing requirements needed when mounting additional units within a

standard 19” Rack System.

2. Description

The OnQ 19” Drawer Façade, 1U is a formed piece of sheet metal with three mounting holes. When mounted

to a 19” OnQ Custom Rack Drawer, this Façade will use 1 unit of space within a standard 19” Rack System

(see Figure 1).

3. Installation

A. Mounting onto a 19” OnQ Custom Rack Drawer

1. Line up the three mounting holes located in the Façade to the three mounting holes in the top

of the Drawer.

2. Install the three #6-32UNC-2B x .38 lg. self-tapping screws into the holes and tighten (see

Figure 2).

Figure 2

This manual is also suitable for

Download PDF