Astria Fireplaces Sirius Instruction Sheet

Brand: Astria Fireplaces

Model: Sirius

Category: Fireplaces

Type: Instruction Sheet

This manual is also suitable for

Astria Fireplaces Sirius is a versatile gas fireplace that offers a range of features for customizable comfort and ambiance in your home. With its adjustable flame height and variable heat output, you can tailor the fireplace to your desired level of warmth and coziness. The included remote control allows for convenient operation from anywhere in the room, while the sleek and modern design complements any décor. Whether you're looking to create a romantic atmosphere or simply add a touch of warmth to your living space, Astria Fireplaces Sirius is the perfect choice.

HEARTH PRODUCTS

KITS AND ACCESSORIES

GLASS DOOR REMOVAL/INSTALLATION

GLASS DOOR REMOVAL/INSTALLATION INSTRUCTIONS. FOR USE WITH RHAPSODY™,

SIRIUS™, DRL3000 AND DRL6500 LINEAR DIRECT-VENT GAS FIREPLACES

[MODEL NUMBERS: Rhapsody42TEN, Rhapsody54TEN, Sirius42TE(N/P), Sirius54TE(N/P)], DRL6542TE(N/P), DRL6554TE(N/P), DRL3042TE(N/P) and DRL3054TE(N/P)

Figure 2

Glass Door Assembly

Figure 1

Door

trim

Barrier

frame

Notches

REQUIRED TOOLS

• #3 Phillips Head Screwdriver

WARNING

HOT GLASS WILL CAUSE

BURNS. DO NOT TOUCH

GLASS UNTIL COOLED.

•Remove glass door assembly only when

ﬁreplace is OFF and COLD.

• Do not attempt to touch the front enclo-

sure glass with your hands while the

ﬁreplace is in use.

•The glass on the front of the ﬁreplace

reaches EXTREMELY HIGH temperatures

and can cause severe burns if touched.

Even after the gas is turned off, ﬁreplace

surfaces remain extremely hot.

WARNING

Any safety screen or guard removed

for servicing the appliance must

be replaced prior to operating the

appliance.

AVERTISSEMENT

Tout écran ou protecteur retiré pour

permettre l’entretien de l’appareil

doit être remis en place avant de

mettre l’appareil en marche.

WARNING

Do not operate appliance with glass

front removed, cracked, or broken.

AVERTISSEMENT

Ne pas utiliser l'appareil si le pan-

neau frontal en verre n'est pas en

place, est craqué ou brisé.

CAUTION

RISK OF PERSONAL INJURY

OR PROPERTY DAMAGE.

•Do NOT abuse glass door by striking or

slamming shut.

•Handleglasswithextremecare!Glassis

susceptible to damage; do NOT scratch or

handle roughly while reinstalling the door.

•Never operate ﬁreplace with glass door

assembly removed.

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE

REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.

BARRIER ASSEMBLY REMOVAL

INSTRUCTIONS

1. Gently lift barrier assembly (Figure 1)

approximately 1/4" to release notches

from tabs.

2. Pull barrier forward from unit.

GLASS DOOR REMOVAL

INSTRUCTIONS

1. Remove the (3) screws securing the lower

edge of the glass door assembly to the

ﬁreplace (Figure 2).

2. Grasp the door assembly by the side edges,

swing out the lower edge, and then lift UP

to unhook it from the ﬁreplace, taking care

not to damage the glass.

3. Set aside the screws and door assembly in

a secure location for later reinstallation.

P/N 506020-35

Rev. B, 08/2015

INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • DOOR REMOVAL INSTRUCTIONS

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.

www.LennoxHearthProducts.com

P/N 506020-35 Rev. B 08/2015

1508 Elm Hill Pike, Suite 108

Nashville, TN 37210

IHP.US.com

Innovative Hearth Products reserves the right

to make changes at any time, without notice,

in design, materials, speciﬁcations, prices and

also to discontinue colors, styles, and products.

Consult your local distributor for ﬁreplace

Innovative Hearth Products, LLC .

P506020-35

BARRIER ASSEMBLY INSTALLATION

INSTRUCTIONS

1. Ensure you are observing the notches on

the barrier assembly (Figure 1) for the proper

depth notch relative to the unit tabs.

2. Push barrier assembly toward the unit until

tight and drop assembly into tabs, making

sure notches are fully engaged.

GLASS DOOR INSTALLATION

INSTRUCTIONS

1. While holding the door assembly by the

side edges, hook the top edge to the ﬁre-

place, and then swing the bottom edge in

toward the ﬁreplace (Figure 2), taking care

not to damage the glass.

IMPORTANT! If the lower ﬂange of

the door does NOT clear the lower front

frame of the ﬁreplace (and strikes the

frame as you swing down the door), make

sure the door's UPPER mounting ﬂange is

completely and properly engaged on the

ﬁreplace frame BEFORE INSERTING THE

SCREWS.

Proper door alignment and sealing are

important to the operation and perfor-

mance of the ﬁreplace. Make sure the

door seal is in contact with the frame and

that no air leaks are present.

2. Align the screw holes below the door

assembly with the holes in the ﬁreplace,

and secure using the (3) previously

removed screws (refer to Figure 2).

Astria Fireplaces Sirius Instruction Sheet

Brand: Astria Fireplaces

Model: Sirius

Category: Fireplaces

Type: Instruction Sheet

This manual is also suitable for

Download PDF

report

Astria Fireplaces Sirius Instruction Sheet

This manual is also suitable for

Astria Fireplaces Sirius Instruction Sheet

Related papers

Other documents