Heat Pump Snow Legs Kit
BAYLEGS002 & BAYLEGS003
INSPECTION:
Check carefully for any shipping damage. This must be
reported to and claims made against the transportation
company immediately. Any missing parts should be
reported to your supplier at once and replaced with
authorized parts only.
INSTALLATION:
1. Installation of Heat Pump Snow Legs must be made
prior to connecting refrigerant lines and/or electrical
power to unit.
2. The BAYLEGS002 kit contains (4) 6" mounting legs.
Before placing each leg under unit, remove protective
mylar exposing adhesive pad. Locate one snow leg under
each corner as illustrated in Figures 1 and 3; do this at
all four corners of the Heat Pump.
3. If BAYLEGS003 (4" extension kit) is used, remove cap
from base of BAYLEGS002, insert 4" extension into base
and place cap on top of 4" extension, as illustrated in
Figure 2. This needs to be performed before Step 2.
Additional BAYLEGS003 (4" extension kits) may be
added to achieve desired heights up to 14" maximum.
21
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
IMPORTANT — This Document is customer property and is to remain with this unit. Please return to service information
pack upon completion of work.
HAZARDOUS VOLTAGE - DISCONNECT POWER BEFORE SERVICING
WARNING:
Installer’s Guide
LEGS-IN-1B
18-HE43D1-4
© 2003 American Standard Inc. All Rights Reserved
BASE
4"
EXTENSION
KIT
CAP
CAP HAS TWO GROOVES
1 STRAIGHT
1CURVED
PAD
SNOW LEG
HEAT
PUMP
Figure 1 Figure 2
TYPICAL 4 CORNERS
The Trane Company
A business of
American Standard Companies
For more information contact
your local dealer (distributor)
P.I.
Since the manufacturer has a policy of continuous product and product data improvement, it reserves the right
to change design and specifications without notice.
Installer’s Guide
Literature Order Number LEGS-IN-1B
File Number SV-UN-ACC-LEGS-IN-1B 2/03
Supersedes LEGS-IN-1A 7/02
Stocking Location PI Louisville & Webb/Mason-Houston
3
SNOW LEG
PLACEMENT
CONTROL BOX
CORNER
REFRIGERANT COMPONENT
ACCESS PANEL SIDE
UNDERSIDE OF BASEPAN
Figure 3
UNDERSIDE OF BASEPAN
ANGLED CORNER BASE
ROUNDED CORNER BASE
SNOW LEG
PLACEMENT
ALIGN GROOVE
IN TOP OF SNOW LEG
WITH CONTOUR OF
BASE PAN EDGE AT
EACH CORNER
OR INSTALL
EACH SNOW LEG
WITHIN BASE
AS SHOWN
AT RIGHT
/
