Whirlpool AKR 950 IX WP Program Chart

Brand: Whirlpool

Model: AKR 950 IX WP

Category: Cooker hoods

Type: Program Chart

Whirlpool AKR 950 IX WP is a versatile kitchen appliance designed to keep your kitchen air clean and fresh. It features three fan speed settings, halogen lights to illuminate your cooking area, and a telescopic flue for easy adjustment to fit your kitchen layout. The grease filter is easy to clean and can even be cleaned in the dishwasher. Additionally, the AKR 950 IX WP has a carbon filter that can be washed and reactivated, lasting up to three years.



5019 318 33092

AKR 950 - AKR 959

KARTA INSTALACYJNA

Minimalna odległość od palników: 50 cm (palniki elektryczne), 75 cm

(palniki gazowe, olejowe lub węglowe). Podczas montażu należy

przestrzegać kolejności numeracji (

.....). Nie podłączać

urządzenia do zasilania, zanim nie zostanie zakończony całkowicie jego

montaż. Uwaga! Przewód wylotowy oraz kolanka mocujące (15) nie

znajdują się na wyposażeniu i należy je dokupić.

POPIS INSTALACE

Minimální vzdálenost od sporáků: 50 cm (elektrické sporáky), 75 cm

(sporáky na plyn, naftu nebo uhlí). Při montáži sledujte číslování

(

.....). Spotřebič připojte k elektrické síti až po úplném dokončení

instalace. Upozornění! Nasávací trubka a upevňovací pásky (15) nejsou

součástí vybavení a musíte je zakoupit.

INŠTALAČNÁ SCHÉMA

Minimálna vzdialenost' od sporáka: 50 cm (elektrické sporáky), 75 cm

(plynové sporáky, sporáky na naftu alebo uhlie). Pri montáži postupujte

podľa číslic (

.....). Spotrebič nezapájajte do siete, kým nie je

inštalácia úplne ukončená. Upozornenie! Rúra na odvádzanie dymov a

upevňovacie svorky (15) sa nedodávajú, musíte ich kúpit' samostatne.

ÜZEMBE HELYEZÉSI ÚTMUTATÓ

A tűzhelytől való minimális távolság: 50 cm (elektromos tűzhely), 75 cm

(gáz-, olaj- vagy széntüzelésű tűzhely). A felszereléshez kövesse a

számozást (

.....). A készüléket csak akkor szabad áram alá

helyezni, ha a beüzemelés már megtörtént. Figyelem! Az elvezető cső és

a rögzítőpántok (15) nem tartozékok, így azokat külön meg kell vásárolni.

СХЕМА УСТАНОВКИ

Минимальное расстояние до конфорок: 50 см (электрические

конфорки), 75 см (газовые, керосиновые или угольные).

Последовательность действий при монтаже должна

соответствовать нумерации (

.....). Не подключайте прибор

к сети до тех пор, пока его установка не будет полностью

закончена. Внимание! Выпускная труба и крепежные зажимы (15)

не входят в комплект поставки и приобретаются отдельно.

КАРТА ЗА ИНСТАЛИРАНЕ

Минимално разстояние от печки: 50 см (електрически печки),

75 см (печки с газ, нафта или въглища). За монтаж следвайте

номерацията (

.....). Не включвайте захранването на

уреда, докато инсталирането не е завършено докрай. Внимание!

Тръбата за отвеждане не е предоставена и трябва да се закупи

отделно.

FIȘA DE INSTALARE

Distanţa minimă de la arzătoare: 50 cm (arzătoare electrice), 75 cm

(arzătoare pe bază de gaze, petrol sau cărbune). Pentru montaj urmaţi

numerotarea (

.....). Nu branșaţi aparatul la curent până când nu

terminaţi definitiv operaţia de instalare. Atenţie! Tubul de evacuare și

manșoanele de fixare (15) nu fac parte din dotare și trebuie să fie

cumpărate separat.

INSTALLATION SHEET

Minimum height above cooker: 50 cm (electric cookers), 75 cm (gas, gas oil or

coal cookers). To install, follow points (1

.....). Do not connect the

appliance to the electrical power supply until installation is completed. Warning!

The exhaust pipe and clamps (15) are not supplied and must be bought separately.

RUS

31833092.fm Page 1 Thursday, November 27, 2003 3:46 PM



5019 318 33092

AKR 950 - AKR 959

20b

7-16

20a

31833092.fm Page 2 Thursday, November 27, 2003 3:46 PM



5019 318 33092

AKR 950 - AKR 959

PL SK H RUSCZ BG RO GB

Preliminary information for installing the hood:

Disconnect the power supply at the domestic main switch before carrying out electrical connections.

Place the extraction unit on a flat surface and fit the bottom part of the hood on it

(remove the grease filter/s).

Carry out the electrical connections between the two parts.

Fix the hood to the extraction unit with 6 screws.

Using a pencil, draw the centre line on the wall up to the ceiling to facilitate installation operations.

Attach the hole diagram to the wall: the vertical centre line printed on the hole diagram must match the

centre line drawn on the wall, and the lower edge of the hole diagram must match the lower edge of the

hood: remember that with installation completed the bottom of the hood must be at least 50 cm above

the cooktop in case of electric cookers and 75 cm in case of gas or mixed cookers.

Place the support bracket on the hole diagram so that it matches the dashed rectangle, mark the two

external holes and drill, remove the hole diagram, insert 2 wall plugs and fix the hood support bracket

with two 5x45 mm screws.

Hook the hood to the bracket.

Adjust the distance between the hood and the wall.

Adjust the hood horizontally.

10.

From the inside of the hood, mark the holes for fixing it.

11.

Remove the hood from the bracket.

12.

Drill on the mark (Ø 8 mm - see step 10).

13.

Insert 1 wall plug.

14.

Fit the flue support bracket

to the wall and against the ceiling, use the support bracket as hole diagram

(the small slot on the support must match the line drawn on the wall - step 4) and mark 2 holes with the

pencil, drill the holes (Ø 8 mm), and finally insert 2 plugs.

15.

Fix the flue support bracket to the wall with two 5x45 mm screws.

16.

Hook the hood to the bottom bracket.

17.

Fix the hood with a 5 x 45 mm screw (ABSOLUTELY NECESSARY).

18.

Connect an exhaust pipe (pipe and clamps are not supplied and must be bought separately) to the collar

located above the extraction motor unit.

For extractor operation, connect the other end of the exhaust pipe to the home discharge device. For filter

operation, fix the deflector

to the flue support bracket

with 2 screws and connect the other end of

the exhaust pipe to the deflector collar

(if the collar is not already fitted it should be inserted on the

deflector and secured with 1 screw). Once the steam and fumes have been filtered by the carbon filter

(not provided, to be ordered separately) they are conveyed back to the kitchen through grid

19.

Carry out the electrical connection.

20.

Apply the flues and fix them with 2 screws (

20a

) to the flue support

(

20b

21.

Slide the bottom section of the flue in the special seat above the hood to completely cover the extraction

unit.

Refit the grease filter/s and check for correct hood operation.

INSTALLATION - ASSEMBLY INSTRUCTIONS

31833092.fm Page 17 Thursday, November 27, 2003 3:46 PM



5019 318 33092

AKR 950 - AKR 959

PL SK H RUSCZ BG RO GB

Control panel.

Grease filter.

Halogen bulbs.

Steam deflector.

Telescopic flue.

To clean the grease filter

Wash the grease filter at least once a month.

Disconnect the electrical power supply.

Remove the grease filters -

Fig. 2

: pull the spring

release handle

(f)

downwards, then remove the

filter.

After cleaning the grease filter refit in reverse

order, making sure the entire extraction surface

is covered.

Carbon filter Fitting and Maintenance

Fitting the carbon filter:

Disconnect the electrical power supply.

Remove the grease filter

(f - Fig. 2)

Turn the side knobs 90° and then remove the

filter holder

(g - Fig. 3)

Fit the carbon filter

(h - Fig. 3)

in the filter

holder

(i - Fig. 3)

Refit the filter holder and secure it to the hood

with the screw

(g - Fig. 3)

Refit the grease filter.

Carbon filter maintenance:

Unlike traditional carbon filters, this carbon filter can

be washed and reactivated.

With normal hood use, the filter should be cleaned

once a month. The best way to clean the filter is in a

dishwasher at the highest temperature possible,

using a normal dishwasher detergent. To avoid

particles of food or dirt settling on the filter during

washing and giving rise to unpleasant smells, it is

advisable to wash the filter on its own. After

washing, dry the filter in the oven at 100° C for 10

minutes to reactivate it.

The filter will retain its odour-absorbing capacity for

three years, after which it must be replaced.

Replacing bulbs

Disconnect the electrical power supply.

Use a small screwdriver or any other suitable tool

to prise off

(m-Fig. 4)

the lamp cover

(p-Fig. 4)

Remove the burnt-out bulb.

Replace using 20 W max halogen bulbs only,

making sure not to touch them with your hands.

Close the lighting unit (snap-close).

CONTROL PANEL

Light ON/OFF switch.

ON/OFF and speed 1 selector switch

(small amount of steam and fumes).

B+C.

Speed 2 selector switch

(medium amount of steam and fumes).

B+D.

Speed 3 selector switch

(large amount of steam and fumes).

ABCD

Fig. 1

Fig. 4

Fig. 2

Fig. 3

PRODUCT SHEET

31833092.fm Page 18 Thursday, November 27, 2003 3:46 PM

Whirlpool AKR 950 IX WP Program Chart

Brand: Whirlpool

Model: AKR 950 IX WP

Category: Cooker hoods

Type: Program Chart

Download PDF

report

Whirlpool AKR 950 IX WP Program Chart

Whirlpool AKR 950 IX WP Program Chart

in other languages

Related papers

Other documents