Smeg WD7010TM Owner's manual

Smeg
Brand
Smeg
Model
WD7010TM
Type
Owner's manual

This manual is also suitable for

19 510 0883 01
Smeg S.p.A. - Instruments Division - [email protected]
WD6010 – WD7010
INSTRUCTION SHEET
POWER ON and INTRODUCTION
Give power supply by turning the main switch from position "0" to "I".
On GW6010: The switch is located in the detergent compartment, on the “loading side”. The main switch can only be
accessed with the lower door open.
In the “double door” version there are two touchscreens user interface.
Only on the “Loading side” (“unclean side”): the operator can select a wash and start the cycle. Please do not manually force the
locked doors. A cycle can be started only if the doors are closed.
WASHING CYCLE SELECTION AND START
1. Home screen
2. Washing cycles menu
4. Cycle in progress
MAIN BUTTONS MEANING
Button to enter the COMPLETE MENU of WASHING
CYCLES.
START: to start the selected washing cycle.
Door Control - button for the management of the
locking / unlocking, opening and closing of the doors.
The button takes on a different icon depending on
the port status (closed padlock means door closed
and locked).
STOP: to stop the washing cycle.
CONFIRM: confirmation button.
6010 Hinged door device only: Door Open. If the
door is opened the door-locking and unlocking
mechanism cannot work.
Home: button to return to the previous screen.
MAIN ICONS MEANING
ICON
MEANING
Thermal disinfection program selected.
The cycle was successfully completed.
The washing part of the cycle was successfully completed, but the drying was interrupted or some problems occurred
during the drying.
The cycle failed. Anomalies occurred during operation or the user forced the cycle to stop.
WARNINGS AND ALARMS
ICON
MEANING
Warnings: they consist of signals provided to users, who must acknowledge them (e.g. lack of detergent signal). The user
must act accordingly to the provided signal, in order to restore the right conditions.
Alarms: signals of device malfunctioning. Alarms imply the interruption of the ongoing cycle and the warning to the user.
The user must consult the alarms table in the operating instruction manual to take the advised measures.
The same icon is used to signal the forced interruption of a cycle.
THIS DOCUMENT
Instruction sheet for basic operations.
For all the details concerning the correct and safe use of the devices, for the updated program table, for the interpretation of alarm
messages and for the requirements for installation: Refer to the user manual and program table - full versions.
  • Page 1 1

Smeg WD7010TM Owner's manual

Smeg
Brand
Smeg
Model
WD7010TM
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents