GE
Lighting Solutions
Installation Guide
GESK01 Slanted Ceiling Mount Kit
GESK02 Seismic Bracing Kit
Lumination
TM
LED Luminaires
1
3
2
4
Remove aircraft cable from gripper by squeezing
the top. Then remove cable from cable coupler.
Fit canopy over stud of crossbar, then screw
cable coupler onto stud. Repeat Step 1 to Step 3
on other side.
Feed aircraft cable through slanted cable coupler
and gripper.
Installed.
Remove cable coupler
Junction box
installed into
slanted ceiling
Stud
Squeeze gripper
to release cable
imagination at work
Installation: Slanted Ceiling Mount Kit
IND028-073012
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
1 - 8 8 8 - 6 9 - 4 3 - 5 3 3
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Lumination is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the General Electric Company.
© 2012 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
1 2
Attach bracing cables clamp about 6” above the
Y-cable for both ends.
3
Installed.
Anchor the Side Cable Exit Gated Hook (4 pieces) to
wall or ceiling.
6 inches
Attach clamp
Bracing cables
Bracing cable
Mount to wall or ceiling
Installation: Seismic Bracing Kit
/
