825120104
Type: CK
MO-M 0716
INSTALLATION
&
OPERATING
INSTRUCTIONS
MODEL: CK400
I
N
T
E
R
T
E
K
e5
030224
- 3 -
CONTENTS
product overview__________________________ 4
installation instructions __________________ 4
Before installing . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
placing the ventilator . . . . . . . . . . . . . . . . . . . . . . .
5
fitting the ventilator . . . . . . . . . . . . . . . . . . . . . . . .
5
operating instructions & product care ____ 6
controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
cleaning. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6
changing the halogen lamp . . . . . . . . . . . . . . . . . .
7
service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7
waste management . . . . . . . . . . . . . . . . . . . . . . . . . . .
7
Indicates a potentially hazardous situation, which, if not avoided, could result in death or
serious injury.
Indicates a potentially hazardous situation, which, if not avoided, may result in minor or
moderate injury.
Used without the safety alert symbol indicates, a potentially hazardous situation which, if not
avoided may result in property damage.
Step-by-step instructions
Information
SYMBOLS
The following symbols are used throughout the manual:
CAUTION
!
WARNING
!
CAUTION
READ AND SAVE THESE INSTRUCTIONS
To avoid the risk of accidents or damage to the appliance it is essential to
read these instructions before it is installed or used for the first time. Keep the
manual in a safe place and ensure that all users are familiar with the contents.
Pass them on to any future owner of the appliance.
- 4 -
PRODUCT OVERVIEW
Thank you for choosing this quality cooker hood. It has been designed to give years of troublefree service, provided it
is installed and maintained correctly.
CK400 is intended for use in caravans, motorhomes and boats and designed to be placed above the food preparation
area, preferably built-in to an existing top cupboard. Please note that it has to be placed at a minimum distance of
50 cm from any open flame.
CK400 removes cooking odours as well as damp air and is equipped with:
A detachable, washable filter.
2 built-in halogen lights.
A 3-position switch (half strength, full strength and off).
A 2 speed fan featuring a 12V motor integrated in the roof dome (not in the appliance itself); resulting in better air
flow and more power. It is connected to the exterior via a flexible duct and weatherproof cap for mounting on the
roof of the RV.
•
•
•
•
TECHNICAL DATA
Height (H
1
) 45 mm
(H
2
) 23 mm
Width (W) 400 mm
Depth (D) 275 mm
Motor power 30 W
Voltage 12 V
Capacity 125 m
3
/h
Halogen lights 2 x 10W, 12V GU4
RECESS FOR INSTALLATION UNDER WALL CUPBOARD
D
W H
1
H
2
INSTALLATION INSTRUCTIONS
FIG 1
FIG 2
- 5 -
PLACING THE VENTILATOR
Dometic ventilators avoid condensation, exhaust
fumes and heat built-up, working on the ingeni-
ously simple pressure-differential principle. They
are easy to install, maintenance-free and weather-
proof.
The distance from the gas-stove flame to the
lower edge of the cooker hood must not be less
than 50 cm.
The ventilator part A-B-C should be placed in the
roof, on a surface that is as even and horizontal as
possible. If the ventilator is positioned on a slop-
ing surface, the part A should be rotated so that
one of the three drainage openings points down-
wards. An inclination of up to 20° is acceptable
without reducing the ventilation when the motor
is not running.
FITTING THE VENTILATOR
Make a hole with a diameter
of 105 mm through the roof
of the vehicle.
Place the ventilator part A in the hole
and make a mark of the six screw holes.
Remove part A and apply a thin ring of
some permanently plastic sealing com-
pound around each hole.
Put the rubber ring into the groove
underneath of part A. It is important that
the lower part is firmly tightened so that
the rubber gasket fits closely against the
roof.
Fasten the hood B in the lower part A.
Then, fasten the upper part C in the
lower part A.
Make a hole in the bottom of the cup-
board, see FIG 2.
Fasten the ventilator hood D with
screws. Fit the hose to the fan and hood
and tighten the hose with the hose clips.
Connect the fan to the battery according
to the figure.
Should the appliance ever need to be dismantled,
follow the installation instructions in reverse
order as described.
1.
2.
3.
4.
5.
6.
7.
8.
Fuse holder with a T4 A fuse 5x20 mm
Spare part number for fuse: 385 80 65-01
White
Black
Red
Blue
1.
2.
3.
4.
5.
INSTALLATION INSTRUCTIONS
1
105 mm
BEFORE INSTALLING
Before installing, please check the following:
Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable
codes and standards.
Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning
equipment to prevent back drafting.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
Ducted fans must always be vented to the outdoors.
To reduce the risk of fire, only use ductwork classed HB or better.
✓
✓
✓
✓
✓
A
B
C
D
3
4
4
2
2
5
From
the Fan
From the
battery
1
3
5
FIG 3
- 6 -
CLEANING
General instructions
Please observe that the surfaces and controls are suscep-
tible to scratches and abrasions. All external surfaces and
controls can be cleaned using warm water with a little
washing-up liquid applied with a sponge or cloth. Wipe
the surfaces dry using a soft cloth.
Do not use cleaning agents containing soda,
acids, chlorides or solvents. Avoid abrasive
cleaning agents, e.g. powder cleaners or cream
cleaners and abrasive sponges as these will dam-
age the surface material. Furthermore, do not
use too much water when cleaning the controls.
Water could penetrate into the electronics and
cause damage.
Cleaning the fan lter
The fan filter absorbs grease in cooking fumes and
requires cleaning now and then. How often depends
on how much the cooker is used and for how much the
fan is in operation. Remove and clean the filter regularly
and do not wait until the suction power of the fan begins
to decrease noticeably. Please note that an oversaturated
filter is a fire hazard.
To clean the filter, follow these steps:
Remove the filter by gently sliding it to the
side (a). Pull it downward and push to the other
side. The filter will drop out (b).
Clean the filter. Either by hand, using a soft nylon
brush, warm water and a little washing up liquid
- or - in a dishwasher where the filter should be
placed with the short side upright in the lower
basket, ensuring the spray arm is not obstructed.
Wash using a 65 °C (145-150 °F) programme.
Depending on the cleaning agent used,
cleaning the filters in a dishwasher can
cause permanent discolouration to the
surface. However, this will not affect the
functioning of the filters in any way.
Reinstall in reverse order of removal. Make
sure the filter is securely engaged.
1.
2.
3.
CONTROLS
Fan motor
Light
Half speed
Low light
Off
Full speed
High light
To turn the cooker hood on/off
Press the Fan motor switch
to turn the cooker hood on/off.
Depending on the intensity of
the cooking vapours, select
half speed or full speed .
To turn the light on/off
Press the Light switch to
turn the light on/off.
Select low light setting
or high light setting .
Some tips and advice
Using the low light option will extend the life of the
lamps.
Always turn hood ON when cooking at high heat.
You will find it helpful to turn the cooker hood on
a few minutes before you start cooking. This starts
to move the air in the kitchen and will speed up the
elimination of cooking odours.
It is advisable to run the fan for a few minutes after
cooking is finished to neutralise any lingering odors
in the air.
•
•
•
OPERATING INSTRUCTIONS & PRODUCT CARE
WARNING
!
Always disconnect the cooker hood from the mains
supply before cleaning or changing any parts.
b)
a)
- 7 -
CHANGING THE HALOGEN LAMP
To change the lamp, follow these steps:
Halogen lamps get very hot during use and
remain hot for some time after being switched
off. Please allow the halogene lamps to cool
before removing.
Gently pull to remove the lamps from
their sockets.
Replace with halogen lamps of the same
specification (10W, 12V GU4).
SERVICE
In the event of a fault which you cannot correct yourself,
or if the appliance is under guarantee, please contact your
nearest Service Center.
The model and serial number of your appliance are
shown on the data plate, see FIG 4, which is visible when
the filter is removed.
WASTE MANAGEMENT
Appliances bearing this symbol must be
deposited at the designated local reception
point for the disposal of electrical and elec-
tronic equipment. It is not permitted that this
product be disposed of by way of the normal
household refuse collection system.
1.
2.
3.
030224
OPERATING INSTRUCTIONS & PRODUCT CARE
FIG 4
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
