the great outdoors by Minka Lavery 8811-57 User manual

Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
For Outdoor Lantern(Rev. 10/30/2012)
WARNING! SHUT POWER OFF AT FUSE OR
CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
1. Shut off power at the circuit breaker and remove old
fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to misplace any
small part necessary for installation.
3. Pull black, and white wires out of electrical outlet
box.
4. Mount circular strap to outlet box(Fig.1)
5. Connect electrical wires as shown making sure all
wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect the
fixture ground wire to it. If not, connect the fixture
ground wire to the green screw on circular strap.
After wires are connected, tuck them carefully
inside junction box. (Fig.2)
6. To prevent moisture from entering the outlet box
and causing a short, use clear caulking (i.e.
Indoor/Outdoor Silicone Sealant) to outline the
outside of fixture back-plate where it meets the wall
leaving a space at bottom to allow moisture a
means to escape (Fig.3).
7. Align fixture to stud screws on circular strap and
attach fixture with knurled knob.(Fig.1)
8. NOTE: Install the light bulbs in accordance with the
fixture specification..(DO NOT EXCEED MAXIMUM
WATTAGE RATING!). (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-307E-A
“U.S.Patent; D436,208
This product is protected by United States Federal and/or
State Law, including Patent and/or Copyright laws.”
© 1998 Minka Lighting, Inc.
Wall Plug
Fixture body
Top Cap
Finial
Wiring box
Knurled
Knobs
Bottom Assembly
Bottom plate
Stud screws
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Fig.3
Caulking
Backplate
Green Ground Screw
Knurled
Knob
Circular Strap
Mounting Screws
Stud Screws
  • Page 1 1

the great outdoors by Minka Lavery 8811-57 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI