Minka Lavery 72683-66 User manual

72683-66
Brand
Minka Lavery
Model
72683-66
Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
Model # 72681/72682/72683
READ AND SAVE THESE INSTRUCTIONS
WAR N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the fuse box or circuit breaker box
and remove the old fixture, including the mounting
hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clear area. Take care not to misplace any small parts
necessary for installation.
3. Attach circular strap (A) using outlet box screws (B) to
the outlet box (C) (not included).
Note: The side of the mounting plate marked "GND" must
face outside. (Fig 1)
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig.2. Make
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting plate using
the green screw (E) provided. Tuck the wire connectors
neatly into the outlet box (C).
COMPLETING THE INSTALLATION (Fig. 1)
5. Align back plate (F) onto screws (D) and secure with
silicone gasket (J) and ball nut (G) (Fig 1).
6. Install (1) one type A bulb up to 100 watts or CFL or LED
equivalent (not included) in accordance with the fixture
specification. —DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
7. To prevent moisture from entering the outlet box (C) and
causing a short, use clear caulking (i.e. Indoor / Outdoor
Silicone Sealant) to outline the outside of fixture back
plate (F) where it meets the wall leaving a space at
bottom to allow moisture a means to escape. (Fig.3)
Your installation is now complete. Return power to the outlet
box and test the fixture.
Fig. 1
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE
LES CONDUCTEURS DE LA DÉRIVATION SONT
ADÉQUATS.
Caulking
Backplate
Fig. 1
Par# A-021
Circular Strap (1)
Ground Screw (1)
Mounting Screws (2)
  • Page 1 1

Minka Lavery 72683-66 User manual

72683-66
Brand
Minka Lavery
Model
72683-66
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents