2. Minka Group
  3. 342-357
342-357

Minka Group 342-357, 342-172, 342-248, 342-84 User manual

  • Hello! I am an AI chatbot trained to assist you with the Minka Group 342-357 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTALLATION INSTRUCTIONS
Item#342 (New. 02/20/2012)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 2
Fig. 1
MOUNTING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
2. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture including the
mounting hardware.
3. Attach the circular strap (A) over the outlet box using
the mounting screws (B) (Size: #8-32N*L0.5”), the
side of the circular strap (A) marked “GND” must face
out.
4. Thread the two studs (C) part way into the circular
strap (A).
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wires as shown in
figure 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green or
bare copper), connect the fixture’s ground wire to it and
secure with the wire connectors, otherwise, connect
the fixture’s ground wire directly to the crossbar using
the green screw provided. After wires are connected,
tuck them carefully into the ceiling junction box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Place the backplate (E) over the two studs (C)
through the holes, then secure the backplate (E)
against the wall with the two cap nuts (D).
7. Install the light bulb(s) (not included) in accordance
with the fixture’s specification. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
8. Slide the glass (F) onto the backplate (E) and set into
place.
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2143E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
A
C
D
E
F
MIN 90℃ SUPPLY CONDUCTORS
Set# A-020
- Circular strap
- Ground screw
- Mounting Screw*2
/