DPA 4006 Omnidirectional Microphone User guide

DPA
Brand
DPA
Model
4006 Omnidirectional Microphone
Category
Microphones
Type
User guide
d:dicate™ 4006ER Omni Microphone, Rear cable
d:dicate™ 4006ES Omni Microphone, Side cable
A combination of the MMC4006 Microphone Capsule and the MMP-E
modular active cable, this mic is part of the modular d:dicate™ Recording
Microphone series. At any time and with no tools necessary it is possible to
transform the basic 4006E Microphone into a new configuration by combin-
ing it with another d:dicate™ Microphone Capsule or Preamplifier.
Suspension mount & windscreen
Suspend the mic in the mount by securing the hook around the notch on the
preamp. Subsequently twist the cable in the spiral-shaped end of the mount.
This allows the Microphone to hang in its own cable and be adjusted to any
direction by bending the boom.
Mount the foam windscreen on the mic head whenever used outdoors or in
air turbulent situations such as close miking voice in order to prevent wind
or pop noise.
Grids
The d:dicate™ 4006E is supplied with three dierent grids that are used to
change characteristics of the microphone acoustically. Be extremely careful
not to touch the exposed diaphragm when switching grids. Do not attempt
to remove dust as it will not aect the performance of the Microphone.
d p a m i c r o p h o n e s . c o m / 4 0 0 6 E
Service & repair
If you are not satisfied with the characteristics exhibited by this product, please go to
www.dpamicrophones.com/service for instructions.
Warranty
The d:dicate™ 4006ER-4006ES Omni Microphone, is covered by a five-year limited warranty.
CE marking
This product conforms to all relevant directives approved by the European Commision.
DPI-4006E-QG
4015C Compact Wide Cardioid Microphone
A combination of the MMC4015 microphone capsule and the MMP-
'TVIEQTPM½IVXLI' [MHIGEVHMSMHQMGMWTEV XSJXLIQSHYPEV
DPA d:dicate
TM
series.
PERFORMANCE
8LI WYTTPMIH GEPMFVEXMSR GLEVX WLS[W XLI WTIGMEPP] XEMPSVIH
MRHMZMHYEP JVIUYIRG] VIWTSRWI SJ XLI 11' GETWYPI QIEWYVIH
[MXLEPMRIEV114%TVIEQT
8]TMGEPSRERHSJJE\MWJVIUYIRG]VIWTSRWIWSJ11'EXGQ
(2 ft) distance:
[[[HTEQMGVSTLSRIWGSQ'
DPI-4015C-QG
Service & repair
-J]SYEVIRSXWEXMW½IH[MXLXLIGLEVEGXIVMWXMGWI\LMFMXIHF]XLMWTVSHYGXTPIEWIGSRXEGX]SYVRIEVIWX(4%
Microphones representative for support.
Warranty
'MWGSZIVIHF]E½ZI]IEVPMQMXIH[EVVERX]
CE marking
8LMWTVSHYGXGSRJSVQW[MXLEPPVIPIZERXHMVIGXMZIWETTVSZIHF]XLI)YVSTIER'SQQMWWMSR
CLIP & WINDSCREEN
1SYRXXLIQMGMRXLIGPMTEXXLINYRGXMSRFIX[IIRQMGERH<06GSRRIGXSV
1SYRXXLI[MRHWGVIIREXXLIQMGLIEHEJXIVLEZMRKTPYKKIHXSXLI<06
connector.
4006ER d:dicate™ Omni Microphone, Rear cable
4006ES d:dicate™ Omni Microphone, Side cable
A combination of the MMC4006 mic capsule and the MMP-E modular active cable,
the 4006E is part of the modular DPA d:dicate™ Recording Microphones series.
At any time and with no tools necessary it is possible to transform the basic 4006E
microphone into a new configuration by combining it with another DPA microphone
capsule or preamp.
SUSPENSION MOUNT & WINDSCREEN
Suspend the mic in the mount by securing the hook around the notch on the
preamp. Subsequently twist the cable in the spiral-shaped end of the mount. This
allows the microphone to hang in its own cable and be adjusted to any direction by
bending the boom.
Mount the foam windscreen on the mic head whenever used outdoors or in air tur-
bulent situations such as close miking voice in order to prevent wind- or pop noise.
GRIDS
The 4006E is supplied with three different grids that are used to change characteris-
tics of the microphone acoustically. Be extremely careful not to touch the exposed
diaphragm when switching grids. Do not attempt to remove dust as it will not affect
the performance of the microphone.
The pre-mounted silver near-field grid (DD0251) exhibits neutral frequency response
when used in near sound field (direct sound field).
The black diffuse-field grid (DD0297) offers recording accuracy in diffuse sound
field (far field) by compensating for the neutral high frequency loss caused by air
absorption.
The silver trapezoid close-mic grid (DD0254) subtly rolls off the highest frequencies
to create smoother treble response when close miking sources with bright transient
w w w . d p a m i c r o p h o n e s . c o m / 4 0 0 6
4006E is covered by five-year limited warranty.
DPI-4006E-QG
Specifications
Directional pattern
Omnidirectional
Principle of operation
Pressure
Cartridge type
Pre-polarized condenser
Frequency range
10 Hz - 20 kHz
Frequency range, ± 2 dB
20 Hz - 20 kHz
Sensitivity, nominal, ± 2 dB at 250 Hz
40 mV/Pa; -28 dB re. 1 V/Pa
Equivalent noise level, A-weighted
Typ. 15 dB(A) re. 20 μPa (max. 17 dB(A))
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL)
Typ. 79 dB(A)
Total Harmonic Distortion (THD)
< 1 % up to 132 dB SPL peak
Dynamic range
Typ. 117 dB
Max. SPL, peak before clipping
132 dB
Output impedance
100 Ω
Minimum load impedance
2 kΩ
Cable drive capability
100 m (328 ft)
Output balance principle
Impedance balancing
Common Mode Rejection Ratio (CMRR)
> 40 dB
Power supply (for full specifications)
48 V Phantom power (±4 V)
Current consumption
3.5 mA
Connector
XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color
Matte black
Weight
114g (4 oz)
Microphone diameter
16-19 mm (0.6 - 0.75 in)
Capsule diameter
16 mm (0.6 in)
Microphone length
35 mm (1.38 in)
Output voltage, RMS
2.2 V
Polarity
+V at Pin 2 for positive sound pressure
Temperature range
-40 to 45 °C (-40 to 113 °F)
Relative Humidity (RH)
Up to 90%
  • Page 1 1
  • Page 2 2

DPA 4006 Omnidirectional Microphone User guide

DPA
Brand
DPA
Model
4006 Omnidirectional Microphone
Category
Microphones
Type
User guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents