DPA 4017 Shotgun Microphone User guide

4017 Shotgun Microphone
DPA
Brand
DPA
Model
4017 Shotgun Microphone
Category
Microphones
Type
User guide

DPA 4017 Shotgun Microphone is a high-quality audio recording tool designed for professional use. With its supercardioid polar pattern, it excels in capturing focused audio while minimizing background noise. The frequency response of 70 Hz to 20 kHz ensures accurate sound reproduction, making it suitable for various applications like filmmaking, broadcasting, and sound design. The microphone operates on 48V phantom power and features an XLR-3M connector for easy integration with professional audio equipment.

DPA 4017 Shotgun Microphone is a high-quality audio recording tool designed for professional use. With its supercardioid polar pattern, it excels in capturing focused audio while minimizing background noise. The frequency response of 70 Hz to 20 kHz ensures accurate sound reproduction, making it suitable for various applications like filmmaking, broadcasting, and sound design. The microphone operates on 48V phantom power and features an XLR-3M connector for easy integration with professional audio equipment.

d:dicate™ 4017C Shotgun Microphone
A combination of the MMC4017 Microphone Capsule and the
MMP-C Preamplifier with filters, this mic is part of d:dicate™
Recording Microphone series.
Performance
The supplied calibration chart shows the specially tailored individual
frequency response of the MMC4017 Microphone Capsule, measured
with a linear MMP-A Preamplifier.
Typical on- and o-axis frequency responses of MMC4017.
d p a m i c r o p h o n e s . c o m / 4 0 1 7 C
Service & repair
If you are not satisfied with the characteristics exhibited by this product, please go to
www.dpamicrophones.com/service for instructions.
Warranty
The d:dicate™ 4017C Shotgun Microphone is covered by a five-year limited warranty.
CE marking
This product conforms to all relevant directives approved by the European Commision.
DPI-4017C-QG
4017C Shotgun Microphone
A combination of the MMC4017 microphone cap-
sule and the MMP-C preamplifier, the 4017C shotgun
microphone is part of the modular DPA d:dicate
TM
Recording Microphones.
PERFORMANCE
The supplied calibration chart shows the specially tailored
individual frequency response of the MMC4017 capsule, measured
with a linear MMP-C preamp.
Typical on- and o-axis frequency response of MMC
www.dpamicrophones.com/4017C
DPI-4017C-QG
Service & repair
If you are not satisfied with the characteristics exhibited by this product, please contact your nearest DPA
Microphones representative for support.
Warranty
4017C is covered by a five-year limited warranty.
CE marking
This product conforms with all relevant directives approved by the European Commission.
dB
10
0
-10
-20
-30
20 Hz 50 100 200 500 1 kH z 2 5 10 20 40
0
30
60
90
On- and off-axis frequency responses measured at 60 cm (23.6 in)
4017C Quick Guide.indd 1 27/02/14 11.38
Specifications
Directional pattern
Supercardioid, lobe-shaped
Principle of operation
Pressure gradient, with interference tube
Cartridge type
Pre-polarized condenser
Frequency range
20 Hz - 20 kHz
Frequency range, ±2 dB
70 Hz - 20 kHz at 60 cm (2 ft)
Sensitivity, nominal, ±2 dB at 1 kHz
19 mV/Pa; -34.4 dB re. 1 V/Pa
Epuivalent noise level, A-weighted
Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A))
Output impedance
< 150 Ω
Output balance principle
Signal balanced
Common Mode Rejection Ratio (CMRR)
> 40 dB
Power supply
48 V Phantom power (±4 V)
Current consumption
4.5 mA
Polarity
+V at Pin 2 for positive sound pressure
Connector
XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Weight
68 g (2.4 oz)
Operating temperature range
-40 to 45°C (-40 to 113°F)
Relative humidity
Up to 90%
  • Page 1 1
  • Page 2 2

DPA 4017 Shotgun Microphone User guide

4017 Shotgun Microphone
DPA
Brand
DPA
Model
4017 Shotgun Microphone
Category
Microphones
Type
User guide

DPA 4017 Shotgun Microphone is a high-quality audio recording tool designed for professional use. With its supercardioid polar pattern, it excels in capturing focused audio while minimizing background noise. The frequency response of 70 Hz to 20 kHz ensures accurate sound reproduction, making it suitable for various applications like filmmaking, broadcasting, and sound design. The microphone operates on 48V phantom power and features an XLR-3M connector for easy integration with professional audio equipment.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents