2. BLOTZ
  3. B28-ME-001

BLOTZ B28-ME-001 Assembly Instructions

  • Hello, I have read the instructions for the BLOTZ 28mm Middle Eastern Building model, B28-ME-001. This document provides a step-by-step guide on how to assemble the building using laser-cut components, including the walls, roof, door, and support structures. I'm ready to answer your questions about the model and its construction process.
  • What type of glue is required for assembly?
    What tool is required to remove sections from the sprue?
    Can sandpaper be used during construction?
28mm Middle Eastern Building #1
B28-ME-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the front, rear and centre walls from the
sprue.
Glue them together to form an “H” shape as shown
above.
Glue this to the base.
Take the two end walls…
..and glue them into position.
Take the roof supports.
Glue them into place so that they stick out
through the walls (see pic)
Glue the door into position.
Place (do not glue) the roof pieces in position
them glue the trapdoors to them.
The finished building.
/