Amerimax 4605 Operating instructions

Type
Operating instructions

This manual is also suitable for

Installation Instructions
Snap together
Connection for a
2” x 2” and 2” x 3”
Cut line for 3” x 4”
downspout
Installation
over elbow
Flex to install
over downspout
without an elbow
Before installation of the StealthFlow, or any downspout extension, make sure the grade around the
foundation slopes away from the house. There should be a 6 inch fall in the first 10 feet from the house.
6 in
10 Feet
Make sure the extension is sloping
away from the foundation
If a watertight seal is preferred, follow one of these following options:
Starting on the side, run a bead of
silicone caulk inside the flared female
end of the StealthFlow connections.
Using corrugated pipe tape / PVC
black tile tape,simply tape around
the seams.
Option #1
Option # 2
The purpose of downspout extensions is to move the high volume of rainwater from the roof and direct it
away from the foundation. Any water that may seep from the connections will be less than the amount of
water actually saturating the surrounding ground from the rainfall.
Accessories
Extensions Elbow
© 2018 OmniMax International, Inc.
450 Richardson Drive
Lancaster, PA 17603
An OmniMax Company
  • Page 1 1

Amerimax 4605 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI