Ecler CA SERIES Presets Contents Save and Recovery User manual

CAseriespresetssaveandrecall

page1/4

ENGLISHVERSION



CAseriesPresetscontents,saveandrecovery



1.Introduction



The CA series devices (CA40, CA200z) can store a total of 5 presets, or global

configuration“pictures”ofthedevice.OncetheyhavebeensavedintotheCAdevice

memory, recalling a preset is just like changing the full CA device configuration

instantaneously,withasetofparameters’values(volumes,EQ,etc.)thatmatchthose

onesthedevicehadwhenthepresetwassaved.By recallingpresets,theendusergets

a fast and friendly way to change the working mode of the CA device, adapting it to

differentapplicationneeds.



Apresetcanbesavedby3differentmethods:

 Usingthefrontpanelcontrols(exceptCA40)

 Using the TP‐NET third‐party protocol, from an external device (SAVE_PRESET

<PresetNumber>)

 UsingtheEclerCOMMsoftwareapplication



Anditcanberecalledby4differentmethods:

 Usingthefrontpanelcontrols(exceptCA40)

 Using an external device (WPm series, for instance), connected to a 0‐10VDC

REMOTEportintheCAdevice

 UsingtheTP‐NETthird‐partyprotocol, from anexternal device( LOAD_PRESET

<PresetNumber>)

 UsingtheEclerCOMMsoftwareapplication



2.ParametersincludedandexcludedinPresets 



Thesearetheparameterswhosevaluesarestoredinapresetatthetimethepresetis

savedintheCAdevice’smemory:



 INPUTsselection(peroutputzone)

 INPUTsvolumelevel,bassandtrebleadjustments

 OUTPUTsvolumelevelandMUTEstatus

 MICROPHONEinputsNoiseGateenable/disablestatus(CA40excluded,

configuredbyhardwaredipswitches)

 MICROPHONEinputsTalkover/PagerfunctionON/OFFstatusstatus(CA40

excluded,configuredbyhardwaredipswitches)

 MICROPHONEinputsNoiseGateandTalkover/Pagerparameters(threshold,

attenuation,attacktime,etc.)

 PanelLockedON/OFFstatus(frontpanelhardwarecontrols)



CAseriespresetssaveandrecall

page2/4



Andthesearethegeneraldeviceparameters,whicharenotpreset‐dependant(they

arenotstoredinapresetwhenitissaved,thusthey’renotmodifiedwithapreset

recall):



 AMPLIFIERworkingmode:STEREO,MONO,BRIDGE,ZONES(CA40:configured

byhardwaredipswitches)

 Auto‐StandbyfunctionON/OFFstatus(CA40:configuredbyhardwaredip

switches)

 REMOTEportON/OFFstatus(CA40:configuredbyhardwaredipswitches)

 REMOTEportinputs/presetsselectionmode

 Preset#1automaticrecoveryatstartup

 Infraredreceiverenable/disablestatus(CA40:notapplicable)

 LCDmodewhenidle:ON,OFF,DIMMED

(CA40:notapplicable)

 LCDcontrastvalue(CA40:notapplicable)

 ZONELABEL(CA40:notapplicable)

Ecler CA SERIES Presets Contents Save and Recovery User manual

Related papers

Other documents