2. JasonL
  3. SP1080AL,9116WT

JasonL SP1080AL,9116WT, SP1080AL, SP1080AL-1, SP1080AL-1,MW.VS.1670WT, SP1080AL-1,MW.VS.1870WT Operating instructions

  • Hello! I've reviewed the assembly instructions for the Sapphire Disc Counter Height Base. This document outlines the necessary tools and steps to put the base together and attach the table top. It emphasizes the importance of using power tools and securing all screws to guarantee stability. I'm ready to assist with any questions you have about the setup process.
  • What tools are required for assembly?
    What if there are pre-drilled holes in my table top?
    Why is it important to fully tighten the bolts and screws before attaching the top?
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Sapphire Disc
Counter Height Base
Page 01
Note: Please ignore any pre-drilled holes or nut inserts that maybe present in your top(s). They will not match your particular
table/desk base and woods screws will be required to be screwed directly into the underside of the top.
Note: It is important to fully tighten all bolts and screws before attaching the top(s) so that the frame is suciently rigid.
Failure to do this may aect stability once the tops are attached.
Tools Required: Power screwdriver. We strongly recommend using an impact drill gun together with thread locking all screws.
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Sapphire Disc
Counter Height Base
STEP 2STEP 1
Page 02
A * 1 B * 1
C * 1
G * 8 woodscrews
D * 3 (M8*30mm)
E * 3 (M8*30mm) F * 1
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Sapphire Disc
Counter Height Base
STEP 3
Page 03
STEP 4
Adding the Top
Screw the table top through the
square top plate using woodscrews
(G*8 wood screws) through the
following holes.
Ask a second person to help to
turn the table and base over.
Careful: tables are heavy.
G
/