Hubbell Wiring Device-Kellems PD2622 Installation guide

Hello! I've reviewed the provided installation instructions for Hubbell's wire channels. This document provides instructions for CFB46WW, CFB4WW, AFB2WW, CFB2WW, and CFB10WW models. It covers their use with 2, 4, 6, and 10 gang floor boxes, emphasizing circuit separation and secure attachment using #6-32 screws. I'm ready to answer any questions you might have about these wire channels or their installation.
What type of screws are used to attach the wire channels?

What is the recommended torque for the screws?

What should I do before installing or servicing?

Installation Instructions

English

PD2622 (Page 1) PRINTED IN USA 05/14

Wiring Device-Kellems

Hubbell Incorporated (Delaware)

40 Waterview Drive

Shelton, Connecticut 06484

1-800-288-6000

WIRE CHANNELS FOR 2, 4, 6 AND 10 GANG FLOOR BOXES

Applies to Catalog No.’s CFB46WW, CFB4WW, AFB2WW, CFB2WW, CFB10WW

CAUTION: RISK OF ELECTRIC SHOCK. Disconnect power before installing or servicing.

NOTICE: For installation by a qualied electrician in accordance with national and local electrical codes,

communication standards, the following instructions, and any instruction included with individual devices.

NOTICE: Ensure data/communications circuits are separated from lighting/power circuits in accordance

NEC® and CE code requirements.

CFB46WW wire channel (see gure 1, [2] screws provided) for use with AFB4G50, AFB4G50CHI,

CFB4G30, CFB4G30CR, CFB4G30R, CFB4G30RCR, CFB4G30CI, CFB4G30RCI, CFB6G30,

CFB6G30CR, CFB6G30R, and CFB6G30RCR series oor boxes.

CFB4WW wire channel (see gure 2, [2] screws provided) for use with AFB4G25, AFB4G25CHI, CFB4G25,

CFB4G25CR, CFB4G25R, and CFB4G25RCR series oor boxes.

AFB2WW wire channel (see gure 3, [1] screw provided) for use with CFB2G25, CFB2G25CR, CFB2G25R,

and CFB2G25RCR series oor boxes.

CFB2WW wire channel (see gure 4, [1] screw provided) for use with AFB2G50, AFB2G50CHI, CFB2G30,

CFB2G30CR, CFB2G30R, and CFB2G30RCR series oor boxes.

CFB10WW wire channel (see gure 5, [1] screw provided) for use with AFB10G55, AFB10G55CHI,

CFB10G55, CFB10G55CR, and CFB10G55RCR series oor boxes.

CAUTION: PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.

See Figures for wire channel installation.

Fig. 1 Fig. 2 Fig. 3

Fig. 4 Fig. 5 Fig. 6

• #6-32 x 3/16” length screws provided.

• Attach wire channel to oor box using

#6-32 screws.

• Tighten screw to 8-10 in. lbs [.90-1.12

Nm] of torque.