A West Security Systems AW-2020 User manual

Brand: A West Security Systems

Model: AW-2020

Type: User manual

The A West Security Systems AW-2020 is an alarm screen with an embedded transmitter, designed to enhance your home security system. It operates wirelessly at a frequency of 345 MHz and is compatible with most alarm control panels. The device features a long battery life with a 3V 1500mAh Li-MnO2 battery, ensuring reliable operation. It is easy to install and program, allowing you to set the desired zone number, zone type, partition, and report code. The AW-2020 provides peace of mind by alerting you to potential threats and helping to protect your property.

ALARM SCREEN with EMBEDDED TRANSMITTER

INSTRUCTION MANUAL

FEATURES:

Transmitter, housing/casing, magnet

PROGRAMMING:

1. Refer to alarm control panel’s instructions for detail on enrolling a wireless transmitter.

2. Select the zone number, zone type, partition, report code, input device type, etc…

3. When prompted to enroll the unit, open the transmitter housing at the latching end

approximately ½” until the alarm panel responds. Then close the housing back into the

screen frame. Optional method would be to record the transmitter serial ID number directly

to the alarm panel.

4. The control panel should acknowledge the transmitter’s serial ID number.

5. Enter the desired loop number for the current zone.

BATTERY REPLACEMENT:

Remove transmitter housing/case from the screen frame. Unplug battery connector leading to

the battery pack. Replace with new battery pack. Slide the new battery pack into the screen

frame, then re-install transmitter housing/case.

SPECIFICATIONS:

Operating Temperature: 32* to 170* F (0* to 77* C)

Operating Relative Humidity: 5 to 95%, non-condensing

Operating Frequency: 345 MHz

Battery Type: Li-MnO2 3V 1500mAh

• For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15

devices. As such, they have limited transmitter power and therefore limited range.

• A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio

signals that occur on or near their operating frequencies, regardless of code setting.

• Changes or modifications to the device may void FCC compliance.

• Infrequently used radio links should be tested regularly to protect against undetected interference or

fault.

• A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor

or dealer, and these facts should be communicated to the ultimate users.

This device complies with FCC Part 15 Rules and Regulations. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

A West Security Systems AW-2020 User manual

A West Security Systems AW-2020 User manual

A West Security Systems AW-2020 User manual

Other documents