Surrounding Camera

KUFATEC Surrounding Camera User manual

  • Hello! I've reviewed the Installation Instructions for the Kufatec 4 Camera System. This document details how to install a four-camera system for your vehicle, including front, rear, and side mirror camera placement, cable routing, and control unit assembly. It also mentions the need for coding after installation for full functionality. I'm ready to help answer your questions about the system.
  • What type of camera system is this?
    What additional feature is included in this system?
    What is needed after installation to make the system fully functional?
Installation Instructions
Surrounding Camera - 4 Camera System
Park Assist Front & Rear Available
v1.0 (23.11.2021)
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected] 1
Contents
1 Liability Exclusion 3
2 Copyright 4
3 General notes 4
4 Safety Instructions 5
5 Requirements for the intended use 5
6 How to connect a cable to another 6
7 Note Cable Inscription/Color 7
8 Assembly Instructions 8
9 Assembly Note 9
10 Note HSD cables 9
11 Disassembly front bumper 10
12 Disassembly engine compartment coverings 13
13 Disassembly coverings driver’s side front 14
14 Disassembly door covering driver’s side front 16
15 Disassembly side mirror driver’s side 18
16 Conversion side mirror driver’s side 19
17 Disassembly loudspeaker 22
18 Disassembly ventilation grilles 23
19 Disassembly main unit 24
20 Disassembly coverings passenger’s side front 25
21 Disassembly back seat passenger’s side 26
22 Disassembly coverings rear passenger’s side 27
23 Disassembly side covering trunk passenger’s side 28
24 Disassembly tailgate covering 29
25 Disassembly tailgate handle / Assembly rear view camera 30
26 Assembly control unit 31
27 Assembly front camera 32
28 Cable routing from the rear view camera to the control unit 33
29 Cable routing from the control unit to the main unit 34
30 Connection main unit 35
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected] 2
31 Connection gateway / ground / steady plus 36
32 Cable routing door front driver’s side 38
33 Cable routing from the front camera to the control unit 40
34 Coding with Coding Interface 42
35 Coding interface 42
36 Bus rest 42
37 Assembling the vehicle 43
38 Note calibration 43
39 Additional vehicle function 43
40 Connection/Troubleshooting cable set 44
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected] 3
8 Assembly Instructions
The following illustration shows the cable routing as well as the position of the individual components.
1
2,3
4,5
67
1
2
3
4
5
6
7
Figure 3: Vehicle overview
1 Front camera
2 Ground, steady plus, gateway connection
3 FAKRA cable connection
4 Side mirror camera driver’s side
5 Side mirror camera passenger’s side
6 Control unit
7 Rear view camera
Please be aware that this overview is only for illustration purposes. Always lay the cable set in the
most convenient and shortest way possible. For a detailed description of the cable routing,
please refer to the relevant sections of the following manual.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [email protected] 9
/