Samlexpower SINGLE RACK PLATE for SEC-POWER SUPPLIES Owner's manual

Assembly Instructions

Item Number : 58170

19” 2U size rack-plate for 1 pcs SEC-1212G/1223/1225G/1235G/2412G

The rack-plate is designed to integrate your power supply into a 19” 2U rack mount power

supply.

Please read the following instructions to ensure proper installation.

Tools required : Philips #2 screw driver

Hardware included : Rack-plate

1. Turn the power supply "Off" and unplug the AC power cord from the AC power source.

2. Unscrew the 4 small cover screws located on the sides of power supply cover.

Untwist the screws about 1 1/2– 2 strokes.

3. Align the screws on the side of the power supply with the grooves on the rack-plate.

4. Push the power supply very carefully into the grooves and slide the power supply to-

wards the front of the rack-plate. Be aware that the screws at the back of the side of

the power supply got into the groove as well.

5. Evenly tighten the 4 screws on the sides of the power supply to secure the power sup-

ply to the rack-plate.

6. You are now ready to use your power supply as a 19” rack mount power supply. .